Electrical Engineer

Sapsol Technologies•Tarrytown, NY

About The Position

We are seeking a hands-on Electrical Engineer for the development, integration, characterization, and troubleshooting of subsystem-level electrical testers. This role is highly technical and execution-focused, with a strong emphasis on practical hardware engineering. The ideal candidate should have 4–8 years of recent hands-on experience in designing and building electronics and semi-automated test systems, integrating hardware/software, and debugging complex electrical issues.

Requirements

Bachelor’s degree in Electrical/Mechanical Engineering or related field
4–8 years of hands-on experience in: Test system development Subsystem-level electrical integration & characterization
Experience in: Analog & digital circuit design/debugging Power electronics (low-voltage/high-current systems)
Strong troubleshooting skills using lab tools
Experience across full lifecycle: concept → build → bring-up → support
Wire harness design & routing
Electrical schematics interpretation
NX Routing (3D harness design)
Component selection & validation
Strong analytical and communication skills

Nice To Haves

Embedded subsystems
Motion control systems
Sensor & transducer technologies
Power distribution systems
Communication protocols (CAN, Ethernet, RS-232, RS-485)
Medical device experience
Familiarity with industry standards
Exposure to PLM tools and change management
EMI/EMC knowledge in harness design

Responsibilities

Tester Development & Integration
Design, build, and maintain subsystem characterization testers: Power distribution and protection Signal conditioning and measurement Control, interlocks, and safety circuits
Develop custom test hardware (fixtures, wiring harnesses, test jigs)
Integrate testers with: Mechanical fixtures Sensors, actuators, power electronics, embedded systems Lab and production environments
Electrical Characterization & Debugging
Perform subsystem electrical characterization: Voltage/current measurements Signal integrity and timing analysis Noise and grounding
Troubleshoot issues in: Analog and digital electronics Power supplies, converters, motor drives Communication interfaces (I²C, SPI, UART, CAN, Ethernet, USB)
Hands-On Lab Execution
Execute testing in lab environments: Bring-up of testers and subsystems Debug under schedule pressure Support verification and troubleshooting
Use lab equipment: Oscilloscopes, logic analyzers, DMMs, power analyzers Environmental and stress testing setups