Electrical Engineer, Motor Controllers

Weave Robotics•San Francisco, CA

About The Position

Weave designs and builds its own actuators for bimanual robots operating in customer homes. The Electrical Engineer, Motor Controllers will own motor controllers and the motors they drive, including gate drive, power stage, current sensing, feedback interfaces, and FOC bring-up and tuning. The role carries controllers from architecture through production, in collaboration with firmware, mechanical, and manufacturing teams. The controllers must support robots that are powerful, precise, safe, quiet, and efficient enough to operate in homes. The position is based around designing motor controller boards and feedback interfaces, bringing up and tuning FOC on new motor and board combinations, and engineering for quiet operation, efficiency, thermal performance, and EMI/EMC. It also supports manufacturing through design-for-manufacturing and test practices, end-of-line test coverage, and per-unit calibration routines.

Requirements

  • At least 3 years designing motor-drive or power-electronics hardware, such as inverters, servo drives, robot actuators, or e-mobility products.
  • Solid grounding in BLDC/PMSM machine fundamentals.
  • Hands-on experience implementing or tuning FOC on real hardware, including current loops, SVPWM, and sensor calibration, and understanding how board design affects torque ripple, acoustic noise, and dead-time distortion.
  • Experience designing complex multilayer PCBs in Altium or a similar tool, from schematic capture through layout and bring-up.
  • Knowledge of switching-stage layout requirements, including power-loop area, Kelvin connections on shunts, gate-drive routing, and plane strategy.
  • Experience with EtherCAT, CAN/CAN FD, SPI, I²C, and other embedded serial buses and real-time industrial networks.
  • Comfort with embedded C or Rust for firmware bring-up and debugging, including tuning loops, instrumenting boards, and diagnosing control behavior.
  • Hands-on debugging experience using oscilloscopes, current probes, and electronic loads.

Nice To Haves

  • Experience with anti-cogging compensation, motor-parameter identification pipelines, or acoustic-noise reduction.
  • Sensorless or observer-based commutation experience.
  • Functional-safety experience in motor drives, including STO or redundant sensing.
  • Experience taking motor-drive hardware through EMC compliance.
  • Experience shipping production motor controllers in consumer products.
  • Experience with GaN or high-voltage systems.

Responsibilities

  • Design motor controller boards, including gate drive, power stage, current sensing, MCU, and protection circuitry, from schematic through layout, bring-up, validation, and production across different voltage and current requirements.
  • Design and own feedback interfaces for encoders, halls, phase-voltage sensing, and thermistors, including signal conditioning, noise immunity, and current-sampling timing and synchronization.
  • Bring up and tune FOC for new motor and board combinations, including current loops, encoder-offset calibration, motor-parameter identification, and dyno verification of torque accuracy and smoothness, in partnership with the firmware team.
  • Engineer switching behavior, PWM strategy, thermal design, and EMI/EMC for quiet and efficient operation in a consumer product used near people.
  • Support production through DFM/DFT, panelization, test-point and programming strategy, end-of-line test coverage, and per-unit calibration routines.
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service