Electrical Assembler I

Mark Andy Inc•Chesterfield, MO

5d•Onsite

About The Position

Perform duties required to assemble electrical and pneumatic components into all inline presses and press equipment for final shipment. Tests, calibrates, and troubleshoots inline presses and press equipment. The summer schedule is 4x10 off Friday, with a 30-minute lunch.

Requirements

Knowledge of circuit components and operation
Ability to read electrical schematics
Troubleshoot using schematics
General knowledge of basic electricity
Ability to add, subtract, multiply and divide in all units of measure.
6 months electrical experience or electrical schooling

Responsibilities

Assemble electrical and pneumatic components such as switches, relays, terminal blocks, wiring, air gauges, air lines, fitting, etc., into electrical sub-assemblies such as, control panels, printed circuit boards, counters, harnesses, registry boxes, etc.
Assemble various components per engineering drawings by using schematics, point to point drawings and diagrams.
Inspect components prior to assembly for visual defects and damages.
Rework component if defect or damage is minor.
Inspect and test sub-assemblies, after assembly, for proper electrical and pneumatic operation using test fixtures, where applicable.
Troubleshoot sub-assemblies using schematics to locate wiring errors or defective components.
Assist engineering department in redesigning and building sub-assemblies for prototype presses.