Coatings Technician

Aaa Usa•Port St. Lucie, FL

About The Position

The Powder Coating Technician performs manual and robotic pre-process grit blasting for thermal spray on components, following specifications and interpreting results. The role also supports coating preparation, braze and heat treatment operations, including masking, furnace operation under direct supervision, brazing, equipment setup and maintenance, and inspection and documentation of work. The technician may work independently on assigned tasks and correct non-conforming hardware during reconditioning where applicable. The position requires willingness to travel or permanently relocate to Jupiter, Florida, or Stuart, Florida, and is offered as temp-to-perm with immediate placement.

Requirements

  • High school diploma or GED equivalent.
  • Complete EHS-assigned regulatory training for the work area, including initial and annual Hazardous Waste Management training.
  • At least 2 years of manufacturing experience with specific skills in at least one of these areas: grinding, blending coatings, coatings application, coatings removal (strip line), blasting, heat treat, machining, welding, or a similar skillset.
  • At least 2 years of experience interpreting technical drawings or work instructions.
  • At least 2 years of experience in a production or maintenance environment.
  • Comprehensive knowledge of manufacturing processes.
  • Basic knowledge of MS Office programs, SAP, timekeeping applications, and folder structures.
  • Willingness to travel or permanently relocate to Jupiter, Florida, or Stuart, Florida.

Responsibilities

  • Visually inspect serial numbers and part condition to verify whether parts are acceptable.
  • Interpret inspection documentation findings and respond according to established procedures.
  • Track and manage tooling and consumable inventories.
  • Perform liquid and tape masking on components with appropriate tools and equipment according to work instructions and drawings to maintain coating allowances.
  • Perform manual and robotic pre-process grit blasting for thermal spray on components according to specification and interpret results.
  • Use precision measuring equipment as required to check work and record results in an electronic database.
  • Inspect own work and the work of others before parts move to the next operation.
  • Operate atmospheric and vacuum furnace controls under direct supervision and load and unload own work.
  • Follow furnace loading configurations and AMS2750 requirements, including using job aids at relevant locations.
  • Assist operators with equipment setup and tooling maintenance.
  • Operate small cranes and forklifts to move equipment, parts, and materials.
  • Enter and confirm required quality documentation.
  • Report and monitor abnormal production time by production step.
  • Perform scheduled and unscheduled maintenance on equipment and tools.
  • Follow Environmental Health and Safety regulations in a fast-paced environment.
  • Continuously improve operations and the work environment using 5S methodology.
  • Independently perform assigned technician work and correct non-conforming hardware during reconditioning where applicable.
  • Perform limited thermal spray booth operations under direct supervision.
  • Train entry-level technicians in coating preparation, braze, and heat treatment.
  • Set up and install brazing equipment according to process requirements.
  • Perform brazing on gas turbine components according to technical specifications for joining and putty braze.
  • Grind and blast components for braze preparation according to specification.
  • Advise on or participate in the design and fabrication of brazing tools and fixtures as required.
  • Report technical deviations to the Cell Lead or Supervisor.
  • Keep the work environment and machines clean and in proper condition.
  • Perform other duties as assigned.

Benefits

  • Paid time off (PTO)
  • Paid holidays
  • Health benefits
© 2026 Teal Labs, Inc
Privacy PolicyTerms of Service