Coating Inspector

E2 Consulting Engineers, Inc.•Naperville, IL

1d•Onsite

About The Position

E2 is seeking an experienced Coating Inspector to support Nicor Gas natural gas pipeline construction and integrity projects across Illinois. In this critical field role, you will be responsible for verifying that all field-applied coatings, joint coatings, and coating repairs meet Nicor Gas specifications, manufacturer requirements, and regulatory standards.

Requirements

Minimum of 2 years of experience inspecting natural gas pipeline construction projects.
Hands-on experience inspecting field-applied pipeline coatings.
Ability to read and interpret construction drawings, alignment sheets, and valve maps.
Familiarity with DOT 192 and OSHA regulations.
AMPP CIP Level 1 certification (or equivalent).
Ability to read, interpret, and apply Company procedures and specifications.
Required Operator Qualifications (OQ) per contract documents.
Strong attention to detail and ability to work independently in the field.
Proficient in Microsoft Word and Excel.

Responsibilities

Daily Coating & Construction Inspection: Inspect Other Contractors' work for compliance with permit requirements and one-call (call before you dig) regulations. Immediately communicate any deviations to the Chief Inspector and Company. Verify that field coatings on pipe, fittings, valves, joints, and other components are applied in accordance with Company procedures and coating manufacturer instructions. Perform coating inspections including holiday detection (jeeping), mil thickness verification, hardness testing, and visual assessment of coating condition. Inspect and verify proper installation of shrink sleeves and other joint protection products.
HDD, Backfill & Pre-Commissioning Activities: Witness all HDD pull-throughs to verify proper pipe support, coating protection, and as-built documentation. Examine the leading edge of the pull-back to ensure no coating damage occurred. Prior to all backfills, HDD pull-throughs, and jack & bores: Visually inspect pipe for coating defects, gouges, dents, or other damage. Verify all pipe has been properly jee ped and any holidays repaired. Confirm field-applied coatings meet Company mil thickness and manufacturer hardness specifications. Inspect shrink sleeves and other joint protection products for proper installation. Verify proper padding, bedding, and rigging practices to prevent coating damage. After all HDDs, verify that visible pipe and weld joint coatings were not damaged during pull-through activities.
Quality, Safety & Documentation: Complete and submit Daily Inspection Reports, coating inspection forms, safety inspection forms, and other required documentation. Verify that construction equipment and material quantities are accurately captured on Daily Progress Reports. Confirm environmental Best Management Practices (BMPs) are followed in accordance with permits and project plans. Witness hydrostatic testing and verify equipment calibration documentation. Communicate opportunities to reduce material waste and improve efficiency to the Company.