CMM Operator- 3rd Shift

PCC Talent Acquisition Portal • Crooksville, OH

10d • Onsite

About The Position

Operates coordinate measuring equipment to measure dimensions of castings by performing the following duties. Performs general maintenance on measuring equipment. Reads Dimensional QEI to determine dimensions and tolerance specifications for selected castings. Positions castings on measuring table of equipment, views castings on monitor screen, and turns calibrated cranks on equipment to position control bar, with attached camera, over specified sections of castings. Flips toggles to lock camera in position, activates digital readout equipment, and records specified measurement of casting in inspection sheets. Repeats process to cover all sections of castings, including locations of specified drilled holes and samples of routed castings. Compares recorded measurements to QEI dimensions and tolerances and notifies Supervisor of discrepancies.

Requirements

• High school diploma or general education degree (GED)
• Ability to read and comprehend simple instructions, short correspondence, and memos.
• Ability to write simple correspondence.
• Ability to effectively present information in one-on-one and small group situations customers, clients, and other employees of the organization.
• Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.
• Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.
• Ability to apply common sense understanding to carry out detailed but uninvolved written or oral instructions.
• Ability to deal with problems involving a few concrete variables in standardized situations.
• Knowledge of Manufacturing Software.
• CMM, Touchup, and Vision Qualification

Responsibilities

• Performs general maintenance on measuring equipment.
• Reads Dimensional QEI to determine dimensions and tolerance specifications for selected castings.
• Positions castings on measuring table of equipment, views castings on monitor screen, and turns calibrated cranks on equipment to position control bar, with attached camera, over specified sections of castings.
• Flips toggles to lock camera in position, activates digital readout equipment, and records specified measurement of casting in inspection sheets.
• Repeats process to cover all sections of castings, including locations of specified drilled holes and samples of routed castings.
• Compares recorded measurements to QEI dimensions and tolerances and notifies Supervisor of discrepancies.

What This Job Offers

• Job Type: Full-time
• Career Level: Mid Level
• Education Level: High school or GED