CMD Machine Operator - 1st shift 6-2:30

Maugus Manufacturing Inc•East Lampeter Township, PA

11d•Onsite

About The Position

The Compression Molding “C” operator is responsible for the overall quality of the caps, ensuring smooth operation of the machines, adding compound to machines and keeping the area clean and organized. This is a 1st shift position, working from 6:00 am to 2:30 pm. The starting pay is $16.50/hr with potential for advancement to Level B operator at $17.00/hr, Level A operator at $18.00/hr, and additional pay increases for those interested in becoming a set-up mechanic. Cross-training and other opportunities will arise.

Requirements

High School Graduate or General Education Degree (GED).
Basic computer skills required.
Ability to perform work accurately and thoroughly.
Ability to communicate effectively using the spoken word.
Ability to pay attention to the minute details of a project or task.
Ability to make decisions or take actions to solve a problem or reach a goal.
Ability to identify and correct conditions that affect employee safety.
Ability to wear Personal Protective Equipment (PPE) - Safety Goggles and Hearing Protection.

Nice To Haves

Set-up mechanic for department

Responsibilities

Operate up to 7 molding machines (authorization required for Alliance machines).
Take quality shots every hour and record results on appropriate paperwork.
Prepare production reports and tickets, confirming that item and ticket match.
Inspect caps in cooling trays, and remove excess flash.
Check caps for blisters, burns, cracks, etc. and notify appropriate personnel (Set-up mechanic, QC, Supervisor).
Sweep floor in the department throughout the shift, removing flash and caps to prevent slips, trips and falls.
Add powder to barrels as needed.
Remove barrels of caps from the department, weighing barrels and taking them to the washer.
Turn powder off with HMI control screen when machine or quality issues are identified (Level “C” operators are not permitted to turn powder on).
Record labor entries and material issue in SAP as needed.
Clean inside the cage after the machine has been approved to enter by a Setup Mechanic or Supervisor.
Perform other miscellaneous duties as assigned.