Chassis Prep Technician

Maintainer Corp of Iowa•Sheldon, IA

3d•Onsite

About The Position

The Chassis Prep Technician is responsible for preparing truck chassis for utility body installation. The role performs electrical and cab modifications, installs power take-off (PTO) systems and related components, and drills and prepares chassis frames for mounting hardware. Each chassis must leave this station properly equipped and ready for the next stage of production, in line with work orders, chassis manufacturer specifications, engineering requirements, and company quality and safety standards.

Requirements

Mechanical aptitude and experience using hand and power tools.
Ability to read and follow work orders, wiring diagrams, installation instructions and technical drawings.
Ability to measure accurately and lay out drilling locations.
Familiarity with drilling, fastening, mounting hardware and mechanical assembly.
Ability to identify problems and perform basic troubleshooting.
Strong attention to detail and commitment to quality workmanship.
Ability to work independently and as part of a production team.
Valid driver's license
Willingness to learn electrical, PTO and hydraulic systems; training provided.

Nice To Haves

Basic automotive or truck electrical knowledge.
Previous experience in truck upfitting, automotive repair, truck equipment installation or heavy-duty vehicle manufacturing.
Experience installing PTO systems or working with hydraulic equipment.
Experience modifying vehicle electrical systems.
Experience preparing truck chassis for service bodies, utility bodies or other vocational truck equipment.
Familiarity with chassis manufacturers' mounting and modification requirements.

Responsibilities

Install and route wiring harnesses, switches, lighting and accessory circuits to wiring diagrams and the chassis manufacturer's body-builder guidelines.
Make approved cab modifications, such as switch panels, control mounts and pass-throughs.
Test circuits and confirm all components work before the chassis moves on.
Install PTO units, pumps, drive shafts and related hydraulic components to manufacturer specifications.
Wire and set up PTO controls and confirm the PTO engages correctly.
Measure and lay out drill locations from drawings and chassis manufacturer frame guidelines.
Drill frame rails and install mounting brackets and hardware to the required torque.
Relocate chassis components, such as fuel, DEF or air tanks and battery boxes, when the work order calls for it.
Check completed work against the work order and quality standards before releasing the chassis.
Report chassis damage, missing parts or spec conflicts to the lead before continuing.
Follow all safety procedures, including battery disconnect, and wear required PPE.
Keep tools, equipment and the work area clean and in working order.
Other duties as assigned.