Brazer, 3rd Shift

Johnson Controls

10d•$25 - $30•Onsite

About The Position

Brazes copper to copper, copper to brass, copper to steel, and brass to brass to fabricate header bodies, distributors, and coil assemblies. Tests coil assemblies to ensure there are no leaks. Evacuates DX coils and charges with nitrogen.

Requirements

Experience with brazing copper to copper, copper to brass, copper to steel, and brass to brass.
Ability to fabricate header bodies, distributors, and coil assemblies.
Skill in testing coil assemblies for leaks.
Experience with evacuating DX coils and charging with nitrogen.
Ability to read and understand paperwork or drawings.
Proficiency in selecting appropriate torch, tip, filler rod, and flux.
Knowledge of connecting regulator valves and hoses to gas cylinders and brazing torch.
Ability to adjust gas mixture and pressure for desired flame.
Skill in guiding torch along braze joint and applying filler rod.
Ability to examine braze joints for leaks and repair them.
Familiarity with applying and filling out coil/header labels.
Ability to assemble coil halves.
Willingness to sign off shop floor paperwork.
Willingness to train new or existing employees.
Commitment to wearing all required personal protective equipment.
Adherence to safety and environmental rules.
Responsibility for reporting work-related injuries and near misses.
Responsibility for correcting or reporting unsafe conditions.

Responsibilities

Obtains appropriate paperwork or drawings for each coil/header.
Positions header parts in jigs or fixtures on table & clamps parts together.
Selects torch, torch tip, filler rod and flux, according to material being brazed.
Connects regulator valves and hoses to oxygen and fuel gas cylinders, and brazing torch.
Turns regulator valves to activate flow of gases, lights torch and adjusts gas mixture and pressure, to obtain desired flame.
Holds torch at proper angle to metal and guides along braze joint, applying filler rod to molten area to form weld.
Examines braze joint for leaks.
Locates and repairs leaks in header or coil assembly.
Applies, and fills out if necessary, all required coil/header labels.
Builds tall coils (i.e. assembles coil halves together).
Signs off shop floor paperwork signifying completion of job.
Trains new or existing employees if necessary.
Wears all required personal protective equipment.
Cleans work area at end of shift.
Responsible for reporting work related injuries and near misses to supervision.
Responsible for wearing all required PPE and following applicable safety/environmental rules.
Responsible for correcting or reporting unsafe conditions observed within the plant.