Atarizuke Operator - Mon-Fri 7:30AM-4:00PM

NGK Ceramics USA, Inc.•Mooresville, NC

1d•Onsite

About The Position

Adjusts die patterns (following established rules) as part of the set-up stage for the extruder operations. Follows work instructions, key point sheets and departmental standards and practices; and follows all safety protocols.

Requirements

Must be able to successfully complete all required job training.
High school diploma or general education degree (GED).
6 month manufacturing/warehousing experience or equivalent
CRC Bronze or above
Ability to read and comprehend work instructions. Ability to communicate information in one-on-one and small group situations to other employees of the organization.
Ability to write routine reports and correspondence.
Ability to add and subtract, multiply and divide in all units of measure, using whole numbers, common fractions, and decimals.
Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form.
Ability to deal with problems involving a few concrete variables in standardized situations.

Nice To Haves

Certified Production Technician program completion
Experience with extruder equipment.
Should have knowledge of MS Excel software.
Good organizational skills.
Good communication skills.

Responsibilities

Performs extruder set-up operations by utilizing techniques established through on-the-job training, work instructions, key points sheets and standard departmental practices
Manipulates the extruder pattern by utilizing the technique and pattern criterion established through on-the-job training, work instructions, key point’s sheets and standard departmental practices.
Performs general visual inspections on all incoming tooling, utilizing a light table
Practices good die handling techniques per established departmental practices
Enters accurate and complete data into the company’s information systems
Lubricates the equipment and/or material
Promotes safety, quality, efficiency and productivity in the department
Participates in safety and work related training, as required
Works safely by avoiding forklifts; staying clear of forklift doors; using personnel doors when entering or exiting the buildings; and safely using overhead hoists
Participates in PM (Preventive Maintenance), MMOL (Machine Maintenance Operator Leader), and G5S (Global 5S: Sort, Set in Order, Shine, Standardize, Sustain) activities, including scheduled end of shift duties
Follows all EMS (Environmental Management System) procedures, including the disposal of waste and used materials
This job has no supervisory responsibilities.