Assembler - 1st Shift - Davenport, IA

VetJobs • Nacogdoches, TX

10d • Onsite

About The Position

Eaton’s AER MSD Mission System Division is seeking an Assembler at its Davenport, Iowa location. The role assembles and disassembles a variety of life support, air-to-air refueling, and personal survival equipment systems. The assembler works on aerospace products ranging from partial to complete states, replaces malfunctioning parts or subassemblies, and diagnoses, troubleshoots, and reworks non-conforming units. The role may also involve drilling, countersinking, sanding, and deburring. A variety of tools and equipment are used to produce finished units that meet stated requirements.

Requirements

• High school diploma or GED from an accredited institution.
• Must possess basic math skills.
• Ability to read and evaluate readouts and presentations, including blueprints, assembly drawings, sketches, and analysis sheets, to determine the status of units or components.
• Ability to diagnose and troubleshoot units using appropriate equipment.
• Skill in using power tools, jigs, fixtures, gauges, and measuring and test equipment required by the job.
• Ability to fit, adjust, compensate, and test components under close tolerances using prescribed methods.
• Ability to follow oral and written instructions.
• Good interpersonal skills.
• Ability to work with limited supervision.
• Must currently reside within 70 miles of Davenport, Iowa, unless an active-duty military service member.
• Must be a U.S. person as defined by ITAR: a U.S. citizen, U.S. permanent resident, political asylee, or refugee.
• Employment immigration sponsorship or support is not available for this position.

Nice To Haves

• Experience within a manufacturing environment.

Responsibilities

• Assemble and disassemble aerospace products in any state, from partial to complete.
• Replace malfunctioning parts or subassemblies as necessary.
• Diagnose, troubleshoot, and rework non-conforming units to return them to acceptable status.
• Perform drilling, countersinking, sanding, and deburring when required.
• Use hand and power tools, jigs, fixtures, gauges, and measuring and test equipment to produce finished units that meet stated requirements.

What This Job Offers

• Job Type: Full-time
• Education Level: High school or GED