Assembler-NL Production - 3rd Shift

KDC One•Manitowoc, WI

2d•Onsite

About The Position

To assist the Line Leader in the production of a quality product at specified quantities in a safe and cost-effective manner.

Requirements

High School, HSED preferred.
None, helpful to have some factory experience.
None

Nice To Haves

Some factory experience

Responsibilities

Check the correct identity, quality and appearance of materials, components, supplies and products.
Maintain established quality standards, reporting quality defects to the Line Leader to assure poor quality product is not going into the carton.
Maintain a clean and neat work area.
Follow all safety procedures.
Execute special assignments required by Management.
Put bottles on line in a specified direction, watching for any noticeable defects.
Keep line full and watch for any bottles that fall over or get stuck on the track or filler.
Know where start/stop buttons are for filler and capper.
Make sure the bottles transfer on and off the filler.
Make sure the cap hopper is full of caps.
Dump bottles into bin and break down boxes if necessary.
If line goes down, clean up immediate area before table work.
If there is a jam-up on filler, bottle person helps Line Leader clean the filler and empty unusable containers.
Place spray nozzles and caps into/onto bottles and twist a couple times to set in place before torque machine.
When the line goes down the person should clean up area (caps on floor, bottles that were pulled off the line), fill and open cap/sprayer boxes.
Assemble boxes correctly and quickly so line will be full of boxes at all times.
Insert partitions if order requires partitions.
Keep watch on capper for jam-ups, tipped bottles, no caps and cocked caps.
Notify the Line Leader immediately and go to the problem area and assist the Line Leader if issues occur at the capper.
Watch labeler for jam-ups.
Notify the Line Leader if label rolls are getting low.
Clean work area when the line goes down.
Help do table work when necessary.
Be ready to hit the emergency stop button if the line needs to be shut off.
Pack bottles in boxes looking at every bottle per box for front and back labels and for codes.
Helps person on boxes keep up on boxes or partitions.
Can go and get boxes or partitions for box person.
For heat seal product, check one or two caps to see if heat seal is good.
Pack boxes one-half full.
When in the position of the box maker, keep watch on the capper and labeler for problems.
Pack the remaining bottles into the boxes.
Pack sprayers, caps, and MSDS sheets into each box, if applicable.
Fold flaps down on boxes and push the filled box through the carton sealer.
Keep an eye on the track at end of line in case it becomes full.
Watch for boxes going through taper in case they tip over.
Hit emergency stop immediately if there is a problem on lines end.
Emptying garbage cans.
Sweeping.
Washing tracks.