Assembler - 1st Shift

Eaton Corporation•Davenport, IA

2d•Onsite

About The Position

Eaton’s AER MSD Mission System Division division is currently seeking an Assembler - 1st Shift. This position is located in our Davenport, IA location. The hourly rate for this position is $26.48 per hour. The Assembler is responsible for assembling and disassembling a variety of life support, air-to-air refueling, and personal survival equipment systems.

Requirements

High School Diploma or G.E.D. from an accredited institution is required.
Eaton will not consider applicants for employment immigration sponsorship or support for this position. This means that Eaton will not support any CPT, OPT, or STEM OPT plans, F-1 to H-1B, H-1B cap registration, O-1, E-3, TN status, I-485 job portability, etc.
No relocation benefit is being offered for this position. All candidates must currently reside within 70 miles of Davenport, IA, to be considered. Active Duty Military Service member candidates are exempt from the geographical area limitation.
This position requires the use of information or access to hardware that is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident, i.e., “Green Card Holder,” Political Asylee, or Refugee.
Must possess basic math skills.
Must be able to read and evaluate various types of readouts and presentations, including blueprints, assembly drawings, sketches, and analysis sheets, to determine the status of units and/or their components.
Ability to diagnose and troubleshoot units using appropriate equipment.
Must be skilled in the use of various kinds of power tools, jigs, fixtures, gauges, and measuring and test equipment, as required by the job.
Must demonstrate proficiency in fitting, adjusting, compensating, and testing various components under close tolerances using prescribed methods.
Must be able to follow both oral and written instructions when performing job duties.
Must demonstrate good interpersonal skills.
Must be able to work with limited supervision.

Nice To Haves

Experience within a manufacturing environment.

Responsibilities

Assemble and disassemble aerospace products, in any state, from partial to complete.
Replace malfunctioning parts and/or sub-assemblies, as necessary.
Diagnose, troubleshoot, and rework non-conforming units in order to return them to acceptable status.
Perform drilling, countersinking, sanding, and deburring, if required.
Use a variety of hand and power tools, including drills, sanders, files, grinders, rivet guns, and paint equipment, as well as jigs, fixtures, gauges, and measuring and test equipment, to produce finished units that meet all stated requirements.