Utility Machine Operator

HICKORY CHAIR LLC•Hickory, NC

1d•Onsite

About The Position

Essential Duties: Must have the ability to answer questions from co-workers in regards the product or sets, assist as needed. Must be able to setup and operate a Hauncher as well as a Mortice Tenon. Must check co-workers set-ups for safety and quality. Must have the ability to make parts from shop orders and/or patterns. Required to set up and operate inverted router and router. Must be able to set up and operate the CNC trim and bore and the Richardson trim and bore, and multiple boring machines. Required to set up and operate the bandsaw and variety saw. Must be able to set up and operate the profile shaper, Bell 100 and Bell 24. Required to use a tape measure to verify measurements on the wood. Must be able to set up and run a planer, wide belt sander and a rip saw. Must follow all safety policies and procedures All other duties as assigned QualificationsPosition Requirements: High school diploma or GED preferred Previous machine operating experience Physical Requirements: The physical demands and work environment expectations described below are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. Must be able to walk, stand, climb, stoop, twist, push, pull, and bend over the course of 8 hours Must be able to work in noisy environments Must be able to pick up and load stock onto pallets Frequently lifting/carrying objects up to 30 lbs.; up to 100 lbs. with assistance

Requirements

High school diploma or GED preferred
Previous machine operating experience
Must be able to walk, stand, climb, stoop, twist, push, pull, and bend over the course of 8 hours
Must be able to work in noisy environments
Must be able to pick up and load stock onto pallets
Frequently lifting/carrying objects up to 30 lbs.; up to 100 lbs. with assistance

Responsibilities

Answer questions from co-workers regarding product or sets.
Set up and operate a Hauncher and a Mortice Tenon.
Check co-worker setups for safety and quality.
Make parts from shop orders and/or patterns.
Set up and operate inverted router and router.
Set up and operate the CNC trim and bore and the Richardson trim and bore, and multiple boring machines.
Set up and operate the bandsaw and variety saw.
Set up and operate the profile shaper, Bell 100 and Bell 24.
Use a tape measure to verify measurements on the wood.
Set up and run a planer, wide belt sander and a rip saw.
Follow all safety policies and procedures.
All other duties as assigned