Sheet Metal Helper

Comfort Systems•Nashville, TN

About The Position

S.M. Lawrence has been doing it right for over 100 years. Our foundation of uncompromising integrity, unequaled service and effective project management has led us to where we are today. We are always searching for new and talented people who share our values and are dedicated to the continued success of this company. As a Sheet Metal Helper you will work with the mechanical construction team to fabricate, assemble, and install mechanical systems on various commercial / industrial construction sites. Compensation aspects of the role are dependent upon knowledge, skills and experience.

Requirements

Experience working within the HVAC / mechanical trade preferred.
Willingness to learn to read blueprints and shop drawings.
Experience with basic hand tools and ability to read a tape measure preferred.
OSHA 10-hour preferred.
High school diploma or GED preferred.
Basic math skills including addition, subtraction, multiplication, and division, to perform routine measurements and calculations.
Ability to work with fractions, percentages, and decimals.
Maintain a positive, cooperative, and teachable attitude.
Initiative; self-motivated (driven), self-starter.
Mechanical aptitude
Analytical and problem-solving skills
Regular and punctual attendance.
Ability to work overtime if needed (and approved)
Ability to stand, squat, bend, climb, stoop and comfortably lift up to 50 lbs.
Ability to pass a full background screening and drug screening.
Ability to pass MVR check (if applicable) or must have reliable transportation
Ability to pass a physical ability test.
Ability to travel, as needed, for projects.

Responsibilities

Install a variety of HVAC materials including but not limited to round
Assist with the installation of a variety of HVAC materials including but not limited to: round pipe/spiral duct, flex duct, motorized dampers, fire dampers, splitter dampers, air devices, louvers and air moving equipment
Assist with fabrication or altering of materials using shears, hammers, punches, snips, drills, brakes and bending rollers along with other handheld and power tools.
Install support hangers, make duct connection using clips, drives, nuts, bolts, TDC tape, sealer, sheet metal screws, etc. as needed.
Assist with drilling and punching holes in metal for screws, bolts, rivets and install spin-in, peel and stick, or airtight duct tape, connect to branch duct.
Ability to work from ladder, manlifts and other equipment at various heights.
Perform other related duties or special projects, as assigned.