Injection Mold Process Tech - 2nd or 3rd shift

Cooper Standard•Leonard, MI

1d•Onsite

About The Position

Position Summary: This position is responsible for all activities associated with the setup, process run and tear down of injection mold equipment. 2nd Shift: 3:00pm - 11:30pm 3rd Shift: 11:00pm – 7:30am

Requirements

Ability to operate a forklift/powered lift equipment and overhead crane.
High School Diploma / GED

Nice To Haves

Previous injection molding experience preferred.

Responsibilities

Promotes an atmosphere conscience of health, safety and environmental practices, in support of the Leonard HSE/EMS policies on a daily basis.
Performs daily job duties to the objectives outlined in the Quality Policy.
Understands and performs daily job duties in a manner which supports the Plant goals and Quality objectives.
Set-up/tear down (changeover) and process injection mold tooling and equipment per the job book and per the PC&L molding press schedule.
Verify all associated job documentation is accurate, posted and filled out per the process work instructions. (Start up process verification log)
Maintain material and other process parameters at each assigned injection press area.
6S equipment and injection process area including any TPM activities per established frequencies.
Assist Molding Quality Operators as needed.
Ensure first/last shot sign off occurs.
Assist in production reporting as needed.
Communicate concerns to Quality and Engineering as required (Mold repair requests – green sheet)
Assist in monitoring, communicating and improving process part containment and process improvements through Lean manufacturing projects.