I&E Technician | Hourly | Dominguez, CA

ECOVYST CATALYST TECHNOLOGIES LLC•Long Beach, CA

5d•$52•Onsite

About The Position

The Instrument/Electrical (IE) Technician is responsible for repairing, troubleshooting, installing, and maintaining electrical and process control instrumentation and equipment up to 480 volts while ensuring compliance with all safety and environmental requirements

Requirements

Basic math skills
Moderate computer skills
Ability to read electrical and instrument loop diagrams
Ability to climb ladders, drive a forklift, and use a man lift
Ability to test and repair electrical circuits up to 480 volts AC
Ability to troubleshoot and repair pneumatic and electronic instrumentation loops
Experience with DCS, PLC programming and troubleshooting, control software, and HMI systems
Ability to wear a full-face respirator
Associate degree (A.A.) or equivalent from a two-year college or technical school or an equivalent combination of education and experience

Nice To Haves

ISA Certification Level I or II is highly preferred
California State Dept. of Apprentice Standard Certified Electrician is highly preferred

Responsibilities

Repair and troubleshoot electrical and instrumentation equipment ranging from small motors up to 480 volts
Install new electrical equipment up to 480 volts
Install wiring and conduit up to 2" diameter including bending and threading conduit
Install process control instrumentation such as transmitters, controllers, analyzers, and control valves
Remove and install small piping and tubing
Rebuild and calibrate transmitters and control valves and tune controllers
Maintain and troubleshoot emission monitoring instruments and control equipment
Perform preventive maintenance on instrumentation
Interface with contractors during installation and startup of electrical and process control systems
Facilitate and order parts as needed
Maintain plant electrical and instrumentation records and standards
Support operations in process control
Conduct inspections and tests as required by the Mechanical Integrity (MIMM) program
Operate forklift, man lift, and hand tools including drills, hacksaws, wrenches, and grinders
Complete required on-the-job training for Powered Industrial Trucks, Forklift, and Crane
Follow all HS&E requirements including attending safety meetings, using PPE properly, reporting incidents, and participating in investigations
Assist with writing job procedures and preparing work permits
Participate in PSUSR, PHA, and MOCs
Maintain housekeeping for the I/E shop area and identify waste-reduction opportunities
Ensure equipment such as forklifts, safety showers, and ladders are approved and safe for use