Gauge Lab Tech - Finishing 1st Shift

PCC Talent Acquisition Portal • Douglas, GA

19h • Onsite

About The Position

To shoot x-rays of cast parts per QES instructions.

Requirements

• High school education.
• Three months OJT training.
• Normal initiative and ingenuity.
• Ability to work productively without constant supervision.
• Above average physical effort required.
• Lift 10-25 pounds routinely, 30 pounds occasionally, 12 or more times per hour.

Responsibilities

• Place parts in trays and load parts into X-Ray machine and operate machine to produce legible x-rays.
• Shall be able to organize and report test results.
• Know practical theory and be familiar with and able to use manuals and source books for assistance in utilizing techniques.
• Must be familiar with the type and location of expected defects for the fabrication process used to make the parts.
• Be able to set up and calibrate equipment.
• Be qualified to direct and carry out tests.
• Able to establish techniques and inspection method documents.
• Assure product is properly processed to the applicable method sheets.
• Keep area clean and adhere to safety procedures.
• Meet efficiency standards.
• Perform additional duties assigned by Dept. Supervisor and/or Level III.
• Maintain a positive work atmosphere by behaving and communicating in a manner that gets along with customers, clients, co-workers, and supervisors.
• Make sure x-ray film is transported without mixing film.
• Must be willing to work daily overtime and weekend overtime as necessary.

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED