Sector Sizer - 1st Shift (Output Shafts)

RH Sheppard Co Inc • Hanover, PA

29d

About The Position

The primary responsibility of the Sizer position is to inspect products from components produced internally by 3 to 8 machine operators, while ensuring all quality standards are met. Incumbent must follow inspection QCI’s (Quality Control Instructions) and process control charts. Performs sample, audit, and 100% inspections as appropriate on in process and final parts. Incumbent will work under moderate supervision.

Requirements

• Communication skills, ability to read, write and comprehend instruction
• Ability to stand, stoop, bend, walk, reach frequently throughout the workday
• Ability to lift items up to 25 lbs without assistance
• Knowledge of shop mathematics, i.e. decimals and fractions; Mechanical tools and measuring equipment including shop rule, micrometers and indicators
• Ability to read and understand machine blueprints and GD+T symbols
• High School Diploma or GED
• Basic MS Office skills (Word, Excel, Outlook, PowerPoint, Teams)
• One year of experience in a manufacturing environment
• Experience in shipping/receiving in a production/manufacturing environment
• Completion of forklift certification
• Problem solving skills
• Ability to prioritize and work well under pressure
• Working knowledge of Lean Manufacturing techniques with emphasis on Standardized Work, Continuous Improvement, 5S, and JIT principles
• Ability to work overtime as needed both daily and weekends

Responsibilities

• Adhere to established safety procedures and 5 “ S ” standards required to perform daily duties in this position, including the proper techniques used in lifting/moving of parts
• Inspects various operations including Turning, Milling, Drilling, Boring, Grinding, Shaping, Hobbing and other operations specific to our product lines
• May use the following gauges: bore gauge, snap gauge, O.D. and depth microscopes, scale dial vernier, height vernier, dial and digital indicators, radius gages, protractor, thread gage, plug gage, surface plates, special checking fixtures, and various gauging specific to our product lines
• Inspects first machined piece; sets up parts using information on the blue prints and QCI’s; will document all data on the print and first piece forms and must be able to make the decision to run the job based on the inspection results
• Will work with tolerances from .0002 to .060, angles from 30 inches to 2 degrees, RMS ranging from 5 to 200
• Responsible for communicating to a machine operator and supervisor a defect or unusual condition requiring investigation or corrective action in the form of machine shutdown, adjustments, part sorting, etc.
• Responsible for accurate completion of daily inspection documents, i.e. daily inspection form, first machined piece, QCI-related forms, and Process Control Charts
• Other duties as assigned

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED
• Number of Employees: 101-250 employees