Yar-Craft

Bass Cat & Yar Craft Boats

13h•$14•Onsite

About The Position

We are looking for hardworking individuals to apply to grind edges off de-molded parts and inside of hulls. Cuts and drills necessary holes in hulls and decks. Inspects all boats after production to ensure that all parts are complete and up to quality standards. Performs all assembly and disassembly. Our Yar-Craft team assembles everything in their own building, from boxing to finish, Yar-Craft does it all. This is a first shift position, and the hours are from 6:00 am to 2:30 pm Starting pay for this position is $14.40/hour All positions are safety sensitive. A safety sensitive position is any position designated in writing by an employer, in which a person performing the position while under the influence of marijuana may constitute a threat to health or safety. Qualified candidates will be asked to submit to drug testing.

Requirements

Be able to use small hand tools (grinder, scraper, razor knife, blower, diamond cutter, hole saws, etc.)
Must be able to work in non-climate-controlled environment
Must be able to bend at waist and knees and stand for extended periods of time.
Must be able to climb into and out of interior of boats
Must be able to wear proper safety equipment to include respirator when necessary.
Must be able to work in fiberglass (dust/handling fiberglass items/etc.)
Must be able to handle chemicals (catalyst/resin/foam)
Must be able to lift 50 pounds when necessary to move deck pieces around in the department.
This is a safety sensitive position

Responsibilities

Be able to identify read orders and identify missing or defective parts and be able to replace when necessary if production is not available
Be able to use and maintain a variety of hand tools including screw gun, drill, etc.
Must have strong attention to detail
Keep work area clean and orderly
Follow instruction of Supervisor/foreman/lead
Be able to cut all holes to run wires/panels/graphs
Install premade harnesses
Install lights/switches/dashes/graphs
Build consoles and install
Wire bow section
Clean at end of day
Cut boat out
Install pumps/tanks/plumbing/wiring back end/jack plates/battery charger/battery boxes
Lay out/build wiring harness/blocks/graph harness/trolling motor harnesses
Very technical/intricate – ability to have strong attention to detail/instructions
Be able to install carpet according to order using strong adhesive glue.
Be able to install carpet in both boats and lids
Install locks/hinges on lids/shocks
Mount all lids/finish components/rod box organizers/rod straps and buckles
Install trolling motors/flush mounts/seats
Install rub rail/silicone/end caps
Be able to grind all de-molded parts properly (hulls, decks, small parts).
Be able to lift deck parts with the help of other employees and move to cut & gear area.
Be able to drill foam chambers/foam them/skip grind/sand areas foamed.
Be able to lift/set rail/hull together/glass/sand all areas/paint where needed.
Wipe down, clean, and inspect before sending boat to Finish Department.
Must be able to wear safety glasses and hearing protection.
Perform other duties, assignments and responsibilities as needed.