PMC Systems Technician

Intuitive Surgical•Sunnyvale, CA

29d

About The Position

Primary Function of Position Ensure Equipment, Fixture and Toolings are calibrated before their due date, according to current DOP to assure any Equipment, Fixture or Tooling are available for manufacturing or inspection of any accessories or products manufactured on the site. Executes Preventive Maintenance on time and according to SAP and/or Agile system. Support on Unplanned Maintenance on timely manner and escalate to Engineering any repair not covered by PMC documentation or MPI. Reports any equipment or fixture with low productivity to be evaluated or fixed.

Requirements

Proficient in reading and writing technical and administrative documents with accuracy and minimal support
Able to communicate verbally with internal teams and cross-functional stakeholders to support daily operations
Minimum of 1 year of experience in preventive maintenance
Minimum of 1 year of experience using instrumentation and measurement equipment
Ability to read and interpret equipment drawings and blueprints
Basic knowledge of electronics
Minimum of 6 months of experience diagnosing and repairing pneumatic and hydraulic equipment
High school diploma or equivalent; minimum two years of experience at Intuitive Surgical or relevant experience in Preventative Maintenance and Calibration. Additionally, a minimum of 1 year as a technician in good standing related to Manufacturing Attendance Guidelines and Quality performance is preferred.

Nice To Haves

Ability to work Varying shifts
Ability to work in team environment
Ability to use clocks, timers, calipers, voltmeters, power supplies, rulers, and other test equipment as required
Meticulous attention to detail and orderly habits are required to accurately and completely document testing
Flexibility, willingness to learn new tasks, ability to take-on a variety of responsibilities big and small, and the need to fill-in for others when needed are highly preferred attributes for this position.

Responsibilities

Safety: Follows GMPs and wears safety equipment to perform his/her endeavors
Participates on Safety commission when required and/or safety training
Utilize the correct tooling and equipment according to process or PMC requirement, reporting any condition of wear off or damaged tooling or equipment
Escalates any safety issues with supervisor or manager
Follows 5S methodology on his areas
Reports any safety device on equipment that is fault or is suspicious of been damaged
Quality: Performs PM or Calibration before it expires (due date) and records it's results on SAP
Utilize raw materials (when required) to check equipment, fixture or tooling performance
Follow up / fulfil EE's to be loaded into SAP system after PM or Calibration during unplanned PM or Calibration
Document and execute LOTO process during OOT events
Records Asset on SAP and label it, for any EFT after PM or Calibration is performed
Records on Quality Notifications that require an EE describing problem and verification results
Performs and records PM to equipment, fixture or tooling on any top level EFT and peripheral assets of such EFT
Efficiency: Provide support to external calibration services or suppliers explaining requirements or issues with EFTs under service or calibration
Requires ECOs to Engineering Department or QO Engineer to update or modify any PMC document that not comply current PMC activities or equipment use
Performs installation, diagnostic, repair and maintenance to process equipment, tooling or fixtures that procedures indicate it require
Update files with daily activities
Lead or participates on Continuous Improvement projects, kaizen or just do it events
Creates purchasing request (PR's) for spare parts
Escalates excessive consumption of spare parts
Cost: Sustain and maintain measurement equipment and tooling under his/her responsibility or ISI Property
Calculate spare parts over consumption due to uptime improvements or production incremental in number of cycles per equipment or more production lines
People: Study and records all assigned curriculum by ISU (Intuitive Surgical University)
Creates self evaluation for CIP and MERIT Follows ISI Politic, Rules and code of conduct
Provide support to production and/or Engineering during equipment and/or process validation
Productivity: Review and complete PM to EFT (Equipment, Fixture or Tool) before it's due date in SAP Realize PM or Calibration following EFT documentation in Agile
Supports unplanned PM documenting on EE
Comply with PM's and calibrations required on daily bases and defined cycle time