Engineer IV (WMBJP00002535) Houston, TX

ESRhealthcare•Houston, TX

17d

About The Position

Support Provide Tier IV Level support and provide aid to any issue that may occur in your area or on the projects youre working on. Engineering & Design Read, interpret, review, and redline P&IDs, Electrical and Instrumentation Schematics. Participate in design review of all projects. Led a automation (controls) focused PHA Take complete ownership of Tagging, Symbols and References for all projects Key equipment design parameters design/ operating pressure; design/ operating temperature. Hardware selection of key hardware components Instrumentation suitability for the selected parameters; ranges; alarm set points; trip set points Control panel interfaces signals to/ from main control room and field instruments; hardwired signals; serial linked signals Control loops between the instruments and equipment Ensure project requirements, expectations, or operational points are within WIMS operating philosophies & standards Author and ensure consistency between documents such as instrument index, control philosophy, programs, and C&E. Review of P&ID to check consistency with ESD philosophy PLC Programming Write Logic for SCP and ESD PLC Write logic all transmitters and devices Write Logic for all compressors Write Logic for Scada Packs Write Logic generators Write Logic for Vent Fans Write Logic for Gas Coolers Write Logic for Gas Control Write Logic for Power monitor Write Logic for air compressors Write Logic for ESD Write Logic for Fire and Gas Detectors Setup all devices and input IP addresses Order and Procure Modules and devices for project Request IP address allocations from IT Gas Control Data Test, Point to Point and final data review. HMI Automation Create Screen and alarms for SCP and ESD PLC Create Screen and alarms all transmitters and devices Create Screen and alarms for all compressors Create Screen and alarms for Scada Packs Create Screen and alarms generators Create Screen and alarms for Vent Fans Create Screen and alarms for Gas Coolers Create Screen and alarms for Station Control Create Screen and alarms Daily Report Create Screen and alarms for trending Create Screens alarms for ESD , Fire and Gas Order HMI Machine for Wonderware Order Wonderware License Fat Testing Travel and Conduct Factory acceptance test of Control buildings Travel and Conduct Factory acceptance test of Control Panels Travel and Conduct Factory acceptance test of Motor Control Centers Documents Maintain, test, verify, cause and effect, and IO list. Commissioning Travel and commission the entire station controls and automation system. Test and commission every device tied into the control system as mentioned in PLC Programming and HMI Automation. Test and commission Scada

Requirements

8-10 years of experience preferred
5 years of experience is minimum
Prior oil and gas experience

Responsibilities

Provide Tier IV Level support and provide aid to any issue that may occur in your area or on the projects youre working on
Read, interpret, review, and redline P&IDs, Electrical and Instrumentation Schematics
Participate in design review of all projects
Led a automation (controls) focused PHA
Take complete ownership of Tagging, Symbols and References for all projects
Hardware selection of key hardware components
Author and ensure consistency between documents such as instrument index, control philosophy, programs, and C&E
Write Logic for SCP and ESD PLC
Setup all devices and input IP addresses
Order and Procure Modules and devices for project
Request IP address allocations from IT
Create Screen and alarms for SCP and ESD PLC
Maintain, test, verify, cause and effect, and IO list
Travel and commission the entire station controls and automation system
Test and commission every device tied into the control system as mentioned in PLC Programming and HMI Automation
Test and commission Scada