2nd Shift Cross Functional Entry Level Operator

Wayne Metals LLC•Markle, IN

About The Position

POSITION SUMMARY: The Cross Functional Entry Level Operator is responsible for operating production equipment in accordance with Wayne Metals, LLC and customer specifications. This position involves training and competency development in three key areas: Assembly, Laser Denesting, and Spot Welding.

Requirements

High school graduate or equivalent training or work experience.
Knowledge of arithmetic
Knowledge of blueprint reading
Knowledge of defects.
Ability to lift up to 40 lbs.
Conform to all Wayne Metals, LLC environmental policies, programs and procedures.
Conform to all State of Indiana laws and regulations.

Responsibilities

Associate will be training in three key areas for entry level operator: ASSEMBLY, LASER DENESTING, and SPOT WELD
An Assembly operator will be able to perform the general assembly operations required for the jobs within the department. He consistently meets or exceeds production standards and/or expectations.
A Laser Denester will be able to perform operations of the laser denesting area, including overhead crane operation and certification.
Spot Welder will be trained to run all of the equipment and jobs within the department and can do all set-ups. He/she must consistently meet or exceed production standards and/or expectations.
Under the direction of the area manager or instruction of a Team leader, Cross Functional Operator will be assigned to run production and / or setup equipment upon which he has been trained.
The operator must have the ability to read, write and perform arithmetic. The operator is responsible for the production counts being reported accurately.
The associate should have the ability to use hand tools related to the various machines, which
Operator must maintain a safe, clean, orderly and hazard-free work area, always promote safety and have knowledge of all safety rules, seeing that all work is done in a safe manner. He/she will report any unsafe condition to his immediate supervisor.
Operator must comply with all Wayne Metals, LLC quality system requirements, defect/error prevention, waste reduction, and WM standards. Will be trained and use SPC systems in place for production operations.
Operator should understand production efficiency and ensure he/she is performing per the specified rates and understand that if the rate is too tight or too loose, he/she should advise the Team Lead and/or Area Manager.
The operator shall be aware of the Manufacturing Goals for the Company.
Operator will be responsible for labor reporting through the Visual Manufacturing System; it is critically important to our process, inventory control, cost accounting, capacity planning and staffing. The operator must follow the procedure for labor entry closely and advise his / her superior when there is a problem.