Tile Cutting Sew On Operator

Engineered Floors • Dalton, GA

1d

About The Position

The Tile Cutting Sew On Operator is responsible to sew on rolls according to schedule. Essential Duties & Responsibilities: Scan roll number on each roll. Record roll numbers, yards, etc. of each roll sent through the coater. Sew rolls together. Be sure seams are straight, tightly sewn and ends trimmed as little as possible. Responsible for correct rolls to be sewn. Attach style flags to first roll of each run. Start accumulator and run the correct amount of carpet from the roll into the accumulator. Care should be taken to keep the carpet aligned properly to keep tension adjusted. Keep work area clean. Performance Expectations (if applicable): Lifting is required of cores, and buckets weighing 30 lbs approximately 80 times per shift. Standing is required 80% of the shift. Reaching is required for cores 40 to 100 times per shift. Stooping is required 15 to 30 times per shift for intervals of 1 to 2 minutes. Bending is required for cores 25 to 30 times per shift. Must be able to use scissors. Must be able to use wrenches.

Requirements

• High school diploma or equivalent preferred
• Must be able to read and write and do basic addition, subtraction, division, and multiplication
• Computer knowledge or data entry skills are a necessary part of the job
• Must be able to use scissors
• Must be able to use wrenches

Responsibilities

• Sew on rolls according to schedule
• Scan roll number on each roll
• Record roll numbers, yards, etc. of each roll sent through the coater
• Sew rolls together
• Ensure seams are straight, tightly sewn and ends trimmed as little as possible
• Ensure correct rolls are sewn
• Attach style flags to first roll of each run
• Start accumulator and run the correct amount of carpet from the roll into the accumulator
• Keep carpet aligned properly to keep tension adjusted
• Keep work area clean
• Report all accidents immediately
• Perform any other duties as assigned
• Wear required safety equipment and follow requirements for all areas
• Report any quality, safety, or potential problems encountered while performing the job to management
• Responsible for quality and safety of his/her own output

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED