Tile Cutting Sew On Operator

Engineered Floors • Dalton, GA

20h

About The Position

The Tile Cutting Sew On Operator is responsible to sew on rolls according to schedule.

Requirements

• High school diploma or equivalent preferred.
• Must be able to read and write and do basic addition, subtraction, division, and multiplication.
• Computer knowledge or data entry skills are a necessary part of the job.
• Must be able to use scissors.
• Must be able to use wrenches.
• Lifting is required of cores, and buckets weighing 30 lbs approximately 80 times per shift.
• Standing is required 80% of the shift.
• Reaching is required for cores 40 to 100 times per shift.
• Stooping is required 15 to 30 times per shift for intervals of 1 to 2 minutes.
• Bending is required for cores 25 to 30 times per shift.
• Overtime is required on occasion.
• All accidents must be reported immediately.
• Safety equipment must be worn as required and requirements must be followed for all areas.

Responsibilities

• Scan roll number on each roll.
• Record roll numbers, yards, etc. of each roll sent through the coater.
• Sew rolls together.
• Be sure seams are straight, tightly sewn and ends trimmed as little as possible.
• Responsible for correct rolls to be sewn.
• Attach style flags to first roll of each run.
• Start accumulator and run the correct amount of carpet from the roll into the accumulator.
• Care should be taken to keep the carpet aligned properly to keep tension adjusted.
• Keep work area clean.
• Report to management any quality, safety, or potential problems encountered while performing the job.
• Responsible for quality and safety of his/her own output.
• Perform any other duties as assigned.

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED
• Number of Employees: 501-1,000 employees