Technician (540)

MPP•Falls Creek, PA

3d•$18 - $27•Onsite

About The Position

Assist supervisors by facilitating communication throughout operations. Maintaining quality and safety standards on all sintering furnaces and equipment

Requirements

Communication, multi-tasking, efficient organization of multiple tasks
High School Graduate / GED
When required in specific areas. This includes, but is not limited to safety glasses, with side shields, hearing protection, and gloves.

Responsibilities

Correctly perform the following activities
Must be able to read and interpret a control plan
Must be able to enter and print an NCMR
Verification and use of micrometers
Verification and use of indicators
Verification and use of weight scales
Setup and operate bench centers for Runout check and report
Setup and operate indicator for perpendicularity check
Setup and operate all density scales
Setup and operate all hardness testers
Setup and operate Comparator
Setup and operate Mitutoyo height indicators/surface plate
Visual inspection of compaction
Visual inspection of sintered part (includes metallographic analysis)
Set up and operate CMM, measure and report:
Outside Diameter
Inside Diameter
Spherical Diameter
Roundness of above features
Perpendicularity
Flatness
Position
Concentricity
Width
Change CMM probes and calibrate on manual and DCC machines as well as train others on equipment
Setup and operate snap gauge
Follow all established safety regulations and procedures.
Setup, monitor, and operate all Sintering equipment as needs require.
Advise supervisor, or Operations Facilitator of any part, equipment, and process difficulties.
Follow all instructions as provided on process control plans and any reference documents.
Quality checks based on assigned level of capability.
Gaging care and verification.
Routine cleaning, care of machines, gages, and other equipment used.
Perform inspections for In-Process of existing and new product as required (includes destructive tests, & nondestructive tests)
Use all available gauging to decide fit of product – will include both setup and operation of gauging
Inform supervision of out-of –tolerance conditions
Audit product, process and documentation at furnace areas as required by existing control plans
Verify setups as required
Complete necessary records both written and electronic
Participate in scheduling/prioritizing of work as required through working with master scheduler.
Learn new gauging/techniques as acquired
Perform other duties as assigned
Inspect and/or sort parts as required.
Record keeping (SPC charts, Production reports, Product Routers, etc.)
Follow all standard work for autonomous maintenance.
Participates in ongoing training and continuous improvement activities.