Sr. Tech, Facilities Maintenance - 1st Shift

Cardinal Health•Norfolk, NE

7d•$23 - $35•Onsite

About The Position

What Production Set-up and Maintenance contributes to Cardinal Health Manufacturing is responsible for cost of production and maintenance activities including process improvement, supply chain management, quality assurance, employee safety and engagement, and environmental commitment. Sets up, aligns, monitors, and/or calibrates production equipment. Assists and may perform maintenance on machines and cleans up minor chemical spills in assigned area as well as glassware, ovens, and other equipment.

Requirements

2-4 years of experience, preferred
High School diploma, GED or degree in related field (electrical/mechanical, HVAC, or welding certification), or equivalent work experience, preferred
Applies acquired knowledge and skills to complete standard tasks
Readily learns and applies new information and methods to work in assigned area
Maintains appropriate licenses, training and certifications
Works on routine assignments that require some problem resolution
Works within clearly defined standard operating procedures and/or scientific methods
Adheres to all quality guidelines
Works under moderate degree of supervision
Work typically involves regular review of output by work lead or supervisor
Refers complex unusual problems to supervisor

Nice To Haves

Understanding of FDA regulations surrounding the manufacturing of medical devices, and GMPs, preferred
Experience with Six Sigma and Lean Manufacturing tools, preferred

Responsibilities

Install and connect motors, compressors, control units, fans, evaporators, etc.
Fabricate metal and equipment, install and join ducts, pipes, valves, filters and plumbing lines based on blueprints and equipment specifications
Construct, install, maintain, paint and repair exterior structures, walls, ceilings, floors, roofs, doors, etc.
Connect units to electrical sources, set thermostat control, pressure and refrigerant controls as required
Maintain and repair equipment – remove, disassemble, clean and replace worn or defective parts and filters, maintain PM’s of equipment, clean and vacuum vents and ducts, order and maintain equipment spare parts inventory
Design and size duct work and rooftop air units – assist with HVAC control system
Maintain and repair facility water systems and treatment
Inspect, repair, replace and maintain safety and fire equipment
Use a variety of hand/welding tools and equipment, cutting and bending tools, and power operated drills
Comply with statutory responsibility under the national/federal regulations - take reasonable care of your own health, safety and welfare along with teammates that may be affected by your acts at work
Follow established EH&S procedures and policies and encourage teammates to follow them
Participate in EH&S activities such as: root cause analysis, finding solutions, implementing improvements, inspections, and meetings
Complete and remain up to date on required EH&S training
Follow all ISO 13485, GMP, OSHA and plant/corporate standards, policies, and procedures
Observe all safety precautions and regulations at all times in all areas where duties are performed
Report all safety incidents, hazards, and potential unsafe working conditions
Work overtime as required
Other duties as assigned with or without accommodation