Slice Dip-Coating Operator Trainee (81609)

THE GILL CORPORATION•El Monte, CA

11d•$25 - $30•Onsite

About The Position

The Gill Corporation is one of the world's largest manufacturers of honeycomb, high performance floor panels, cargo compartment liners and original equipment for passenger and freighter aircraft. The company also excels in many other types of reinforced plastics including interior sandwich panels for creating structures such as aircraft galleys and bulkheads, honeycomb core and related products. The Gill Corporation is seeking a Slice Dip-Coating Operator Trainee who processes honeycomb slices/cores in a conveyor system and soaks them with resin. Removes dipped slices/cores and takes them to an oven to cure the resin, and then removes them from the oven to cool. Reporting to the Production Supervisor, they will perform but not be limited to the following responsibilities.

Requirements

High School Diploma
One or two years of related experience and/or training
Forklift Certification a plus
Satisfactory Lung Capacity Test to properly use Respiratory Protection as needed/required
Must be able to communicate, read, and write English to perform all job duties
Must be able to lift, push & pull a minimum of 50 lbs.
Acceptable Spirometry Test results (full/ half respirator use).
ITAR Requirement: This position requires access to information that is subject to compliance with the International Traffic Arms Regulations (“ITAR”) and/or the Export Administration Regulations (“EAR”). In order to comply with the requirements of the ITAR and/or the EAR, applicants will be asked to provide specific documentation to verify U.S. person status under the ITAR and the EAR. A “U.S. person” according to their definition is a U.S. citizen, U.S. lawful permanent resident (green card holder), or protected individual such as a refugee, or asylee.

Nice To Haves

Forklift Certification a plus

Responsibilities

Transports slices/cores to dip tanks, places them in dip baskets.
Notifies the process operator to activate specified dip program.
Removes dipped slices/cores from tanks, delivers them to ovens.
Notifies the process operator to activate specified bake programs.
Removes baked slices/cores from ovens and stages them for further processing.
Shall notify process operator when adding resin and alcohol to dip tanks is required. Process operator to calculate and record the amount of alcohol and resin used per process.
Records densities and all other necessary information on work order and/or dipping software.
May also be tasked to dip blocks in the dipping area depending on production requirements.
Must be available any shift and over-time, including weekends.
Other essential duties may be assigned.