Quality Inspector I - 1st Shift

Cadrex Seguin•Seguin, TX

14d•Onsite

About The Position

OVERVIEW Cadrex is searching for a Quality Inspector I to directly support site manufacturing practices through development, evaluation, and continual improvement of processes using quality concepts, principles and methodologies with the goal of consistently meeting or exceeding customer expectations of quality. KEY RESPONSIBILITIES Use measuring devices such as calipers, micrometers, steel rulers, pin gages, surface plate, and height gage Read and interpret blueprints Visual inspection of product according to customer requirements Inspect and or test in-process product as well as finished product Document inspection results by completing required reports/logs Identify and quarantine all non-conforming product Generate and summarize non-conforming reports for discrepant products Keep measurement equipment operating by following operating instructions and identify and address issues with equipment that may need repair Inspect and approve incoming materials where and when needed by confirming they meet specifications Attend department meetings as required

Requirements

Understand industry safety standards and quality expectations
Read and comprehend simple instructions, short correspondence, and memos. Write simple correspondence
Ability to effectively present information in one-on-one and small group situations to customers, clients, and other employees
Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals
Ability to compute rate, ratio, and percentage and to draw and interpret graphs?
Knowledge of word processing software, spreadsheet software, e-mail software and the use of the internet
High school diploma

Nice To Haves

1 or more years working in a metal fabrication environment under a continuous improvement QMS with hands on inspection preferred
Associate degree in related field preferred

Responsibilities

Use measuring devices such as calipers, micrometers, steel rulers, pin gages, surface plate, and height gage
Read and interpret blueprints
Visual inspection of product according to customer requirements
Inspect and or test in-process product as well as finished product
Document inspection results by completing required reports/logs
Identify and quarantine all non-conforming product
Generate and summarize non-conforming reports for discrepant products
Keep measurement equipment operating by following operating instructions and identify and address issues with equipment that may need repair
Inspect and approve incoming materials where and when needed by confirming they meet specifications
Attend department meetings as required