QUALITY CONTROL INSPECTOR

Cutter Aviation•Englewood, CO

31d

About The Position

A Quality Control/Floor Inspector assists the Chief Inspector with all things as required and needed in support of the Repair Station and operations. This person reports directly to the Chief Inspector.

Requirements

Must have High School Diploma or GED
Must have an FAA approved Airframe and Power plant license.
Sincere desire to assist others.
Able to develop a friendly rapport.
Professional in appearance and mannerisms.
Ability to work independently with minimal direction.
Ability to understand technical publications and requirements.
Clear understanding of FAA and Repair Station requirements.
Assist with or undertake any other duties as assigned by key personnel.
Ability to work with several individuals while showing independence in balancing and prioritizing requests.
Must have a clean driving record.
Ability to pass a background check.
Occasionally required to lift up to 35 pounds.
Must be able to sit, stand, kneel and climb ladders.
Must be able to show up to work on time ready to work.
Must have dependable transportation to and from work.
Ability to pass an initial and random drug screening test.

Nice To Haves

Attention to detail.
Being open to change.
Being reliable, responsible, dependable, and fulfilling obligations.
Willingness to take on responsibilities, accept changes, and challenges.
Accepting criticism and dealing calmly and effectively with high stress situations.
Being pleasant with others on the job and displaying a good-natured, cooperative attitude.
An ability to guide oneself with little or no supervision, depending on oneself to get things done while following the requirements of the Repair Station.

Responsibilities

Maintain a clean and orderly workspace.
Work efficiently with the team to ensure a smooth workflow.
Assist the Chief Inspector with logbook research as required.
Perform aircraft inspections when not inspecting discrepancies or work orders.
Assist the Chief Inspector with floor inspection items. Giving the "ok to close panels" and being the "backup" to ensure quality and safety of our products.
Assist the Chief Inspector with returning aircraft to service after work is completed. Ensure that we are delivering a safe aircraft that meets our quality standards.
Inspecting discrepancies once completed for proper repairs, correct paperwork, and correct sign-off of discrepancies. (Make sure accepted or approved procedures are used at all times.)
Other duties as assigned.