Punch Press, Set Up Tech - Class B 3rd Shift

Automatic Spring Products Corporation•Grand Haven, MI

About The Position

The Punch Press Set Up Tech Class B is responsible for Setting up and operating a single and automatic power press that feeds continuous roll of sheet metal into position under ram by performing the following duties. Also, assumes responsibility for general housekeeping duties and striving toward continuous improvement.

Requirements

High school diploma or GED required.
Experience running high volume automated punch presses.
Ability to read and follow written and verbal work instructions.
Demonstrated ability to complete complex work independently with precision and care.
Ability to read and understand quality related documents, general understanding of the company quality standards and expectations, and other related documents and instructions.
SPC and Sensor Experience
Ability to learn from others and retain information related to the job, such as how to use calipers, micrometer, read and understand blueprint.
Regular and consistent attendance is essential.

Responsibilities

Performs routine operation of the press(s), the auxiliary equipment, and general maintenance of the press(s).
Perform all required shift start up and shift end functions.
Perform all required Q.C. checks.
Make minor adjustments to air lines, oil lines, and straightener rollers.
Keep the machine and surrounding area clean and free of debris, excessive oils, and obstructions.
Isolate and make out any non-conformance paperwork for suspect parts.
Complete the appropriate paperwork for die or sensor damage.
Complete accurate work orders for the maintenance and tool room departments as required via computer as needed.
Tagging and pulling dies at the end of the run.
Set-up compound dies and reset progressive dies.
Make minor adjustments to sensors, cams, and ram settings. (Any changes made to cams, sensors, and ram settings must be documented and initialed on the appropriate set-up sheet).