Painter Nightshift

Drake-Williams Steel•Omaha, NE

6d•$20 - $30•Onsite

About The Position

Primary Purpose of this Position: Paint parts for structural fabrication, Service Center, and misc. steel assemblies per cutting lists, shop drawings, and DWS quality requirements.

Requirements

Ability to read, write, and perform higher arithmetic computations involving addition, subtraction, multiplication, and division of whole numbers, decimals and fractions.
Ability to effectively communicate with co-workers, supervisors and managers.
Ability to work under periodic supervision focused on the progress of work and setting priorities for job completion.
Skill in using auto measurer, tape measure, or 1” rule.
Ability to interpret, understand and utilize cutting lists, shop orders, and shop drawings.
Ability to use a computer for cut-lists and inventory purposes.
Ability to possess pride in own workmanship; demonstrate attention to detail, and work safely.
Ability to multi-task.
Pencil, Tape Measure, Markers, Wire Brushes, Pipe Wrench, Scrapers, Grab Hooks, 4” grinder, Ball-Peen Hammer, Pry-Bar, Beam Bar, Band Cutters, Chains, Airlines, Chainsaw, and Paint Lines.
Overhead Crane, Jib Crane, Paint Guns, Paint Pumps, and Forklifts.
High School degree or equivalent.

Nice To Haves

Minimum of six months of experience in a shop environment preferred.

Responsibilities

Identify steel shapes, sizes, and mill tolerances.
Paint material as trained and instructed.
Paint beams, tubes, angle, channel, bar grating, pipe, plate, or rounds according to the shop drawings, AISC code requirements for structural steel, and machine capabilities.
Make adjustments to machine to ensure accurate mill thickness as shown on the shop drawings.
Identify shop drawing errors and discrepancies before or during early stages of paint.
Operate forklifts, jib cranes, overhead cranes, conveyors, and transfers in order to move materials.