Operator II

Dentsply Sirona, Inc

About The Position

The Operator II is expected to be able to perform the requirements of an Operator I. Additionally, the Operator II is proficient across all lines in the department and is used as a training and troubleshooting resource for the department. This job function directly ☒ indirectly ☐ affects product quality

Requirements

Must be proficient with using small hand tools
Work independently as well as coordinate and communicate with other team members and departments
Ability to perform basic math calculations and weight conversions
Able to cross train in other areas as assigned
Dependability and ability to adapt to change are essential
Ability to read, write and communicate in English
Must be capable of basic computer interactions and data entry
High School Diploma/GED OR equivalent work experience at the discretion of the Hiring Manager
Must be able to sit/stand for at least 4 hours at a time
Have normal eye/hand motor coordination and the ability to grasp and hold small objects
Possess a normal extended reach
Consistently uses manual dexterity
Have the ability to determine color acuity
Must be able to transport, lift, and demonstrate materials, product and equipment weighing up to 40 lbs
Limited temperature fluctuations, air conditioned environment
Exposure to general manufacturing environment
Non-allergy to Latex

Responsibilities

Understands production and quality metrics and performs accordingly to meet them
Follow work instructions, material preparation procedures, visual aid, and inspection procedures as applicable
Read work orders and follow Bill of Materials (BOM)
Follow established company policies
Follow Good Manufacturing Practices (GMP)
Fill out proper documentation (i.e. traveler, production ticket, daily production report, process verification sheet, etc.)
Follow quality controls inspection points
Perform measurement verification with all relevant Quality equipment
Participate in problem solving activities
Participate in daily continual improvement activities
Maintain a clean and organized work station
Communicate with Supervisor and other team members
Other duties as assigned
Cross train on PW-III, PW-II, and PW-I job duties in the PHX department
Perform Marking machine operations and control
Follow start up and shutdown procedure
Perform basic maintenance as required and fill out applicable 5S, TPM, PM and cleaning check sheets
Set up and calibrate equipment as required
Perform set-up inspection and continuous inspection as required
Perform product change over, cleaning and adjustments
Perform trouble shooting, line clearance, and routine cleaning
Maintenance – fill out PM and cleaning checks sheets.
Perform 1st piece inspection and continuous inspection.
Perform Extrusion dies change over, cleaning and adjustment.
Perform Extrusion trouble shooting, purging and cleaning.
Setup and calibrate adapter less tip size base on required specification program in Zumbach.
Material drying and mixing procedures.
Quality inspection and scrap reporting.
Perform measurement verification with caliper, comparator, scale and pin gauges.
Support Unit Lead in execution of cycle counting program.
Support Unit Lead in schedule compliance in department.