The Boeing Company is looking for a Non-Destructive Test Inspector – Magnetic & Penetrant (Level 2) that is located in Ridley Park, PA . Responsibilities may include but are not limited to the following: Perform quality control inspection to the applicable Method specific procedures. Setup, load, and inspect production parts in accordance with established test programs, calibration standards, and inspection plans. Stamp or otherwise indicate parts of acceptable quality, note flaw indications and prepare and maintain records for parts of unacceptable quality. Compare Company and vendor test results against accepted standards, determine acceptability, and obtain Customer Inspection approval. May be required to perform inspection duties at subsidiary plants, vendor or subcontractor plants. Perform minor repairs to equipment such as replacing fuses, circuit breakers, wires, tubes, and assist in maintenance of Method Specific records and supplies. Plan and write inspection plan documents detailing operations and instructions required to set up test equipment, position parts, and carry out tests. Participate in the development of test programs, procedures, and acceptance criteria for calibration standards. May provide instruction to employees and vendors designated to assist with the above duties. Use all materials, tools, equipment, and instruments and perform work in accordance with drawings, specifications, written, and oral instructions, and Company standards of workmanship, safety, and good housekeeping practices. Security Clearance and Export Control Requirements: This position must meet Export Control compliance requirements, therefore a “US Person” as defined by 22 C.F.R. § 120.15 is required. “US Person” includes US Citizen, lawful permanent resident, refugee, or asylee