Metal Control Coordinator - 3rd shift - 15% Shift Differential

PCC Talent Acquisition Portal•Northfield, NH

2d•$19 - $25

About The Position

Perform diversified duties to prepare daily production and melting schedules, to prepare charges for furnaces, and to maintain related controls and records. Perform duties of caster, as needed, and assigned. Work from charge sheets, specifications, alloying formulas and / or any special instructions supplied to weigh out and prepare furnace charges. Make necessary calculations to determine proportional quantities for partial charges. Exercise care in selecting and weighing charge component materials to avoid incorrect alloying, intermingling or contamination. Use hand truck or fork lift to deliver charges to furnace areas. Maintain records of material received, on hand and issued; prepare and maintain individual charge records. Following established methods, obtain and prepare virgin metal and heat samples for chemical analysis, and maintain analysis log of all heats and virgin materials, specified allowing and other related data in established form and detail. Take periodic physical inventories. Maintain inventory control records of all virgin, alloying and scrap material on hand; make receipt and issuance entries, extend and total. Prepare periodic use and level reports following established practice. Notify supervision of apparent shortages or excesses brought about by changed material requirements. Detect faulty operations, defective material and report these and any unusual conditions to supervisor.

Requirements

High school diploma or GED preferred but not required.
At least 3 years of trade experience.

Responsibilities

Prepare daily production and melting schedules.
Prepare charges for furnaces.
Maintain related controls and records.
Perform duties of caster, as needed, and assigned.
Work from charge sheets, specifications, alloying formulas and / or any special instructions supplied to weigh out and prepare furnace charges.
Make necessary calculations to determine proportional quantities for partial charges.
Exercise care in selecting and weighing charge component materials to avoid incorrect alloying, intermingling or contamination.
Use hand truck or fork lift to deliver charges to furnace areas.
Maintain records of material received, on hand and issued; prepare and maintain individual charge records.
Following established methods, obtain and prepare virgin metal and heat samples for chemical analysis, and maintain analysis log of all heats and virgin materials, specified allowing and other related data in established form and detail.
Take periodic physical inventories.
Maintain inventory control records of all virgin, alloying and scrap material on hand; make receipt and issuance entries, extend and total.
Prepare periodic use and level reports following established practice.
Notify supervision of apparent shortages or excesses brought about by changed material requirements.
Detect faulty operations, defective material and report these and any unusual conditions to supervisor.
Comply with all applicable safety requirements, policies and procedures, while maintaining a clean, safe, and orderly work environment.
Participate in required training, medical monitoring, safety, and health evaluations and programs.
Wear required Personal Protective Equipment (PPE) in all designated areas of facility.
Perform all physical functions of position; standing, stooping, bending, sitting, walking, twisting, kneeling, turning and lifting of materials up to 35 lbs.
Meet established attendance standards.
Work overtime as needed.
Report any work-related injury or illness immediately to your direct supervisor.
Perform other duties as assigned.