Maintenance Tech Night Shift

Drake-Williams Steel•Omaha, NE

1d•$25 - $35•Onsite

About The Position

Primary Purpose of this Position: To maintain or repair DWS fabrication equipment, material handling equipment, buildings, facilities, and processes. Work on “projects” that improve the DWS processes. Make building and facility repairs.

Requirements

Ability to read, write, and perform higher arithmetic computations involving addition, subtraction, multiplication, and division of whole numbers, decimals and fractions.
Ability to understand and carry out semi-complicated verbal and written instructions.
Ability to effectively communicate with vendors, co-workers, supervisors and managers.
Ability to work under periodic supervision focused on the progress of work and setting priorities for job completion.
Skill in using tape measure, or other measuring devices.
Ability to pass a Drake-Williams Steel, Inc. administered test that covers shop drawing interpretation, fractional number calculations, basic geometry, etc.
Ability to interpret shop drawings for projects.
Ability to possess pride in own workmanship, demonstrate attention to detail, and work safely.
Ability to operate forklifts and overhead cranes in a safe and proper manner.
Use and understand industry and Drake-Williams Steel adopted hand signals used for crane operations.
Perform minor/major mechanical tasks on machines.
Ability to multi-task.
High School degree or equivalent.
Minimum of six months of experience in a manufacturing environment.

Responsibilities

PM machines based on PM procedures to help ensure machines run properly and efficiently.
Troubleshoot mechanical/electrical issues on equipment that is down.
Contact vendors for supplies and recommendations.
Input information into the Mega Mation tracking system.
Strategically visualize and communicate project plans and supplies needed.
Identify steel shapes, sizes, and mill tolerances for projects.
Operate overhead cranes, forklifts, jib cranes, gantry cranes, conveyors, machines, and transfers in order to PM or repair them.
Any other duties assigned by management (example- plow snow, sand lot, and grounds maintenance.
Attend all meetings as required by management.
Consistently and reliably works scheduled hours at assigned locations.