Center, TX

Tyson Foods•Center, TX

14d•Onsite

About The Position

This position is responsible for troubleshooting, maintaining, and repairing all equipment and company assets while maintaining a safe work environment and adhering to Tyson policies and procedures. General Maintenance positions are responsible for keeping machinery running to maintain continuous production. You must be able to set up, adjust and break down production line machinery. Position requires knowledge in areas of welding, hydraulics, basic electricity, power transmission, pneumatics and other maintenance related areas. Must be able to learn Tyson SAP software to make work orders, fill out the daily documentation required, perform preventative maintenance routines as scheduled by Supervisor as well as confirm time into the SAP system to record daily activities and create equipment history. Must be able to read and write where required, must be able to communicate with management and co-workers as needed, must be able to process paperwork necessary to position, must be able to use math as needed to make work related computations for machinery, fluid capacities, etc. Must be willing to lift, push, pull up to 70 lbs, climb stairs and ladders on a daily basis, be willing to work in cold environments with temperatures ranging from -10 to 80 degrees in the production area to an environment that is tied to what the weather outside is (rain, heat, cold, insects), wet conditions, slippery floors in some areas, concrete floors and noise levels that are loud enough to require hearing protection and be willing to work on your feet for a period of 8 to 12 hours. Must be willing to complete all required training for the job. The successful candidate(s) must be willing and able to perform the physical requirements of the job with or without a reasonable accommodation.

Requirements

Must be able to set up, adjust and break down production line machinery.
Position requires knowledge in areas of welding, hydraulics, basic electricity, power transmission, pneumatics and other maintenance related areas.
Must be able to learn Tyson SAP software to make work orders, fill out the daily documentation required, perform preventative maintenance routines as scheduled by Supervisor as well as confirm time into the SAP system to record daily activities and create equipment history.
Must be able to read and write where required, must be able to communicate with management and co-workers as needed, must be able to process paperwork necessary to position
Must be able to process paperwork necessary to position
Must be able to use math as needed to make work related computations for machinery, fluid capacities, etc.
Must be willing to lift, push, pull up to 70 lbs, climb stairs and ladders on a daily basis, be willing to work in cold environments with temperatures ranging from -10 to 80 degrees in the production area to an environment that is tied to what the weather outside is (rain, heat, cold, insects), wet conditions, slippery floors in some areas, concrete floors and noise levels that are loud enough to require hearing protection and be willing to work on your feet for a period of 8 to 12 hours.
Must be willing to complete all required training for the job.
Maintenance MG02-MG08: 6 months industrial maintenance experience and/or general experience required.
Preferably to include welding, electrical, hydraulics.
180 days wait period from last termination date.
3X rule (candidates cannot have worked for Tyson 3X before).