Heat Treat Operator Level I

PCC Talent Acquisition Portal • South Gate, CA

8d • Onsite

About The Position

Position Summary: Oversees heat treatment of open and closed die forgings, in house conversions of ingots, billets, and rolled rings, with minimal supervision. Primary Duties & Responsibilities: Possesses thorough understanding of controlling and monitoring all heat treat furnaces as well as their limits and capabilities. Prepares furnace loads, dependent upon material type and quantity allowable in furnace. Verifies piece count and straightness and flatness of parts before and after material is heat treated. Performs cold and hot straightening if necessary. Conducts hardness inspection of material. Oversees furnace light up and monitoring.

Requirements

• Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals.
• Ability to write routine reports and correspondence.
• Ability to speak effectively before management and other Company employees.
• Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals.
• Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.
• Ability to apply common sense understanding to carry out instructions furnished in written, oral, or diagram form.
• Ability to deal with problems involving several concrete variables in standardized situations.
• High school diploma or general education degree (GED); or three to five years related experience and/or training; or equivalent combination of education and experience.

Responsibilities

• Oversees heat treatment of open and closed die forgings, in house conversions of ingots, billets, and rolled rings, with minimal supervision.
• Possesses thorough understanding of controlling and monitoring all heat treat furnaces as well as their limits and capabilities.
• Prepares furnace loads, dependent upon material type and quantity allowable in furnace.
• Verifies piece count and straightness and flatness of parts before and after material is heat treated.
• Performs cold and hot straightening if necessary.
• Conducts hardness inspection of material.
• Oversees furnace light up and monitoring.

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED
• Number of Employees: 5,001-10,000 employees