Forklift Operator
About The Position
-Load, unload, put-away, stack, pick, stage palletized material using forklift -Ability to work quickly and accurately -Ability to scan barcodes and operate scanning computer -Verify product labeling and inspect pallets and containers -Properly scan all movements of material inbound and outbound -Working knowledge of material handling and stock methods -Perform daily lift truck inspection Will start on 1st shift and then after the 4 weeks of training they will move to their respective shifts. Before the LTO gets on the FL, (unprompted)-must visually inspect for leaks, check the condition of tires, forks, load backrest, hydraulic hoses, mast chains, cables and stops, propane tank, for rust, corrosion, damage and how full is it. Check Overhead Guard, seat belt, fire extinguisher, hood latch. Must use 3 limbs to get on the FL. Must buckle the seat belt immediately after getting on the FL. Explain what the levers do, check lights, once the engine is turned on, check accelerator, brakes (parking/service), Steering operation, drive controls, Raise, tilt, side shift, visually check all belts, horn/lights, hour meter, low fuel light, high temperature light. Follow all directions, Dave will tell tester to back up in a straight line, no curvature, stop at all intersections and honk horn (will not be told to), be a foot in front of containers to stack raise forks, insert into holes, lift containers up, back up a bit, stop, drop the forks to about 6 inches, drive backwards, check both sides of lift to ensure no obstructions and potential accidents, pull back forward, and square off with container stack, restack containers, make sure all sides are locked in and level, remove forks, back up, drop forks, level them, return to parking spot. If unable to make it to work call 309-445-6963 prior to your shift. Potential hazard exposures may include; extreme temperatures, dust, work area will have forklift and material handling items in area, cuts or abrasions from material handling, slip and trip hazards. Preforming strenuous movements, lifting, bending, and kneeling as needed.
Responsibilities
- Load, unload, put-away, stack, pick, stage palletized material using forklift
- Ability to work quickly and accurately
- Ability to scan barcodes and operate scanning computer
- Verify product labeling and inspect pallets and containers
- Properly scan all movements of material inbound and outbound
- Working knowledge of material handling and stock methods
- Perform daily lift truck inspection
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Entry Level
Education Level
No Education Listed
