Finisher - 3rd Shift - Sunday - Thursday; 10:00pm - 6:30am
About The Position
SAFETY practices MUST be exercised by each operator at all times. Use safety devices and equipment provided. Refer to shop manual procedures and types of edge finishing. Finishers will set rolls on finish table, straighten spirals so they are uniform and connect panels with connecting crimp. Once table load is set up, confirm “spirals per foot” from the entry on the shop order. Apply tension and trim spirals. Square the belt. Weld edges of belt in accordance with type of edge required. Inspect belt. Take belt to shipping department once approved by department supervisor
Responsibilities
- Set rolls on finish table
- Straighten spirals so they are uniform
- Connect panels with connecting crimp
- Confirm “spirals per foot” from the entry on the shop order
- Apply tension and trim spirals
- Square the belt
- Weld edges of belt in accordance with type of edge required
- Inspect belt
- Take belt to shipping department once approved by department supervisor
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Job Type
Full-time
Career Level
Entry Level
Education Level
No Education Listed
Number of Employees
11-50 employees
