Finisher I

REV Group, Inc.•Ocala, FL

About The Position

Perform duties to sand, grind, mount, or repair any unit preparation for welding, assembly operations or paint, to meet specifications as part of the manufacture of large, custom, special purpose vehicles, working within the limits of prescribed routines.

Requirements

High School diploma or GED equivalent
Effective communication skills, written and oral
Good math skills
Forklift license (must be able to obtain an E-ONE-issued forklift license)
Recordkeeping abilities
Knowledge of and adherence to E-ONE safety practices

Responsibilities

May sand or grind pats or bevel edged in preparation for welding. May feather, flute, flat and level grind, remove server corners to overcome surface stress areas subject to fatigue fractures or perform other similar conditions. May remove sharp edges or burns, detect dents, holes and substrate Work from process sheet, shop orders, prints, schedule, pick-lists, and instructions.
Review material and production requirements. Obtain and accumulate tools and materials, move to work area.
Blow off and wipe down components or unit to remove grit, grease and other foreign surfaces. Check cab, body or component structure for obvious defects such as dents in panel sections, rough welds beads, fractures, undulations or wavy surfaces and similar conditions.
defects, apply fillers, file or sand area to meet surface finish requirements. May apply primer over corrected areas of body and expose aluminum.
May wire brush welds to remove smoke, grind and remove excess weld beads to smooth surface, remove residue from weld area, and apply compound and buff surface to meet cosmetic criteria and specifications. Recognize and call attention to weld defects such as fractures, voids, porosity and distortion. Check and recognize part surfaces requiring smooth surfaces, sand and apply polishing compound and buff as required. Change grades of abrasive or compounds to suit finishing requirements and to finish surfaces of parts to prepare for future processing or as a final process, clean and buff surfaces such as tread plate, and remove scratches on non-painted surfaces.
May remove doors or other components and place on work stand or fixture, pull required hinges and backup nars and mount in place.
May flat surface sand specified pieces and vary pressure of sander to obtain symmetrical pattern across surface to meet cosmetic requirements.
Monitor the quality of work performed in assigned area of responsibility.
Follow work standards
Must be able to perform within physical requirements including, but not limited to 45 lb. single lift; walking, kneeling, squatting and standing for long periods of time.
Perform or assist with any operations, as required or directed, to maintain work flow or respond to production requirements.
May be required to perform other duties not listed but needed by Supervisor in order to keep trucks on schedule.