Fabrication-2

Barry-Wehmiller • Indianapolis, IN

4d

About The Position

The primary purpose of the fabricator is to drill and tap holes to the proper size for assembly of final product. Holes are drilled, tapped, and/or punched as indicated by marking provided by layout.

Requirements

• Strong work ethic
• Ability to multi-task
• Ability to lift 50 pounds unassisted
• Able to work on feet for extended periods of time
• Reliable mode of transportation

Responsibilities

• Fabricator will select piece from lot and read specifications for size of hole(s) to be drilled
• One at a time the fabricator will select the appropriate bit and insert in drill press
• Process will be repeated until all required holes are drilled
• For larger holes a hole saw is used instead of a bit
• For some holes as many as three holes may have to be drilled – a pilot, then a little larger, then a final size
• After holes are drilled, operator will use countersink bit to deburr both sides of the piece
• After deburring, the fabricator selects the appropriate tap and taps all wholes that require threads as specified
• Occasionally some parts are run on the small punch press when several holes of the same size are required
• This depends on the position of the holes and the thickness of the metal

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: No Education Listed
• Number of Employees: 5,001-10,000 employees