Electrical Lighting Designer II

Rosendin•Pflugerville, NC

15d

About The Position

The Electrical Lighting Designer II is a mid-level designer responsible for creating marked drawings, model development, and other documents showing equipment and device layouts and branch circuiting for power, lighting, and auxiliary drawings. In addition, this position provides calculations and documentation for the design of lighting and power systems, as well as details as required to define and clarify the intent of the design on drawings. This position requires moderate dotted-line supervision by a Designer III, an Engineer, the Engineer of Record, the Engineering Team Lead, or the Director of Engineering.

Requirements

Strong Visual lighting software experience and understanding of Energy codes (such as International Energy Conservation Code and Title 24), including NFPA code requirements such as outlined in NEC and NFPA 101
Knowledge of central battery inverters and battery backups in individual fixtures
Strong understanding of requirements for powering emergency lighting and Lighting Controls (such as Wattstopper)
Ability to do lighting fixture selection while including owners and architects for “architectural” front-of-house type lighting
Site lighting experience including verification of light levels and considerations for issues such as light pollution
Some college or technical training in electrical engineering or architectural engineering related discipline
Minimum 3 years of experience as a Designer I
Can be a combination of educations, training, and relevant experience

Nice To Haves

Experience in data centers preferred but not absolutely required

Responsibilities

Utilize visual lighting software and energy codes (such as International Energy Conservation Code and Title 24") to create lighting designs.
Mark up branch circuit lighting and power plans and fill in panel board schedules with moderate
Perform Energy Code calculations, documentation, and local jurisdiction energy requirements with little supervision.
Apply and perform Rosendin standards for wire sizing, transformer feeders, and protection from published schedules.
Calculate power loads, size feeders, and determine the estimated demand load summary for a distribution system under the direction of a Sr. Designer or an Engineer.
Direct and coordinate signal and low voltage subcontractors with other trades, such as architectural, structural, mechanical, plumbing, fire protection, vertical transportation, kitchen equipment, and OFCI systems.
Create details as required to define installation for construction.
Provide the design lead function for small jobs.
Ability to review manufacturer submittals for electrical characteristics.
Layout Electrical Room, including clearances, with minimal oversight.