Door Patcher

WOODGRAIN Inc.•Leesburg, GA

41d•$17•Onsite

About The Position

The Patcher is responsible for identifying and repairing all rejected components to be reintroduced as highest value component materials. This operation is the final check point for repairs on components. Reports to Department Manager. No supervisory responsibilities.

Requirements

High School Diploma or GED preferred
Previous work experience in manufacturing
Ability to repair components

Nice To Haves

Drives for results
Solves problems and analyzes issues
Communicates powerfully and prolifically
Collaboration and teamwork
Ability to work in a safe and efficient manner
Ability to read, understand, and follow written instructions
Good communication and listening skills
Ability to work well and collaborate in a team environment
Attention to detail
Know species, profiles, and components of products
Ability to perform basic math calculations (add, subtract, multiply, divide)
Ability to use basic measurement tools such as a caliper and tape measure

Responsibilities

Completing quality patches or repairing components using a sander, wood welder and assorted hand tools as necessary
Repairing moulding and reintroducing it to finished unit during the time in which the order is being produced
Extracting the highest value possible from rejected products
Closely inspecting material and repairing material that does not meet specified quality standards
Following production schedule and producing material to the required specifications
Removing components from production if serious defects are discovered
Performing necessary cleaning, general maintenance, and minor troubleshooting to machinery
Daily set-up, routine use, and adjustments to machines according to the Established Standard Operating Procedure (SOP)
Knowing and understanding the different profiles, species, and wood dimensions to successfully run to critical specifications
Handling and maneuvering products in ways that are safe and prevent damage
Read and understand the Job Safety Analysis (JSA) and standard operating procedures related to and posted near the area
Complete safety orientation training, observe all safety policies and procedures, including use of required protective equipment (PPE)
Maintaining a clean and orderly work area
Actively participating in work-area improvements
Assisting other work areas as necessary