Dip Room Operator

Miller Castings INC•Whittier, CA

10d•$19 - $19•Onsite

About The Position

Dip room operations including pattern wash, building of slurries, slurry maintenance, pre-wet, core pack, dipping, stucco, preparation of molds for dewax, dewax and climate control.

Requirements

Basic elementary skills
Ability to work overtime, weekends, and Holidays.
Ability to communicate, problem solving, teamwork and initiative
Show up on time
Ability to comprehend simple instructions.

Responsibilities

Receive molds from Wax Room
Shell Wash
Mold Wash
Bottom Board
Mix Slurry
Clean slurry tanks
Dewax Operation
Hand Dip
Attach hangers and stage for mold wash.
Visually inspect the assembly for any wax defects, pinholes, flash, poor seals, etc.., return for any defective assembly to the Wax Room for repair.
Evacuation of the wax pattern and sprue system is accomplished by one of two methods, either by Steam autoclave or Flash fire
Wash shells after dewax using steam or hot water
Dump old slurry and clean tanks to prepare for a new slurry
Removing the hanger shoe, plastic boot and the pipe nipple after the last dip coat is completely dry and in preparation of the Dewax operation.
Dip molds by hand
Mix slurry base and sock to new slurry
Wear Personal Protective Equipment