Die Setter (2063)

MPP•Falls Creek, PA

5d•Onsite

About The Position

Setup Class C, B and A type parts within the QAD standard. Responsible for the safe setup and operation of equipment. Keep work area clean and organized

Requirements

Ability to organize and prioritize multiple projects
Basic blueprint reading
2 years die setting experience
Ability to setup Class C,B and A type parts with no assistance inall presses, Gasbarre, Cinci or Elmco presses , including Multi level presses
High School Graduate / GED
When required in specific areas. This includes, but is not limited to safety glasses, with side shields, hearing protection, and gloves.

Responsibilities

Maintain daily mold/sizing record
Follow instructions
Follow all established safety regulations and procedures
Follow all instructions listed on PCPs and setup info sheets
Adjust presses when needed
Ensure all press safeties are properly set
Setup Class C,B & A type parts
Keep area clean and organized and put items back where they belong (bolts,backer blocks, rings and collets,etc)
Work with Supervisor and Trainer to train to move to the next level of Diesetting (if not already completed)
Accurately fill out the Daily Production log
Participates in ongoing training and continuous improvement activities
Participates in Tool breakage investigation process
Perform other duties as assigned
Ensure that parts are holding size,wt and density and that all dimensions are in the “center” of the Molding Spec before taking part in to Quality Inspector for initial setup check in
Operate Compaction presses when needed
Correctly perform the following activities
Must be able to read and interpret a PCP
Verification and use of Micrometers and indicators
Basic knowledge in crack detection and prevention
Communicate with Associates on other shifts
Must possess trouble shooting skills