Crew Member, 1st Shift

Owens Corning•Stokesdale, NC

3d•$19•Onsite

About The Position

The primary purpose of this position is to safely stack materials accurately and meet quality standards for material shipments. Must meet all personal performance requirements Must inspect products coming to the machine for defects and proper paint coverage and receive proper sign off on the quality control sheet. Grade material off back of machine to appropriate customer specifications Separate out unsuitable material that would not make grade Demonstrate the ability to pack products to customer requirements, stack sticks, banding, proper count, skids, etc. Keep accurate daily paperwork. Learn to read and process orders on the display monitor Tie up finished units to be pulled and tagged properly Complete putty repairs as needed and repair or re-install weatherstrip if not fully seated Communicate counts and completions of quantities in a timely manner Keep the area clean and organized to 5S standards. Use time during delays to clean around all areas of the machine, with the intent to minimize clean-up downtime required at the end of the shift Assist in other areas as needed

Requirements

Completion of the 9th grade and be at least 18 Years Old
Demonstrate a sense of urgency to perform work duties
Complete knowledge of the grade of all products ran through the machine
Able to communicate orally and in writing
Able to read tape measure, caliper, and spec (details)
Able to troubleshoot problems
Good hand-eye coordination and be mechanically adaptable
Stand for 10 hours straight
Climb and descend stairs/ladder as needed for the role
Do repetitive movements (hand, wrist, and arm)
Able to walk, bend, twist, stoop, climb stairs, and lift approximately 35 lbs.
Withstand heat in excess of 95 degrees
Be exposed to wood dust and aluminum with no factors or hazards present to a disagreeable extent