Concrete Production Laborer - Starting at $20/hr

Fabcon Career•Mahanoy City, PA

4d•$20•Onsite

About The Position

Purpose/Scope Perform production labor work necessary to assist with the manufacture of high-quality concrete products including, but not limited to, wall panels, highway traffic barriers, columns, and sound walls. Essential Duties and Responsibilities Operate jackhammer, forklift, bobcat Follow appropriate work instructions to clean and upkeep all equipment Cut and install wood block outs Set up equipment used for casting bands and finishes Proper placement of concrete on the bed to match the piece drawings Monitor bed heat at computer Lay out the bed with the proper dimensions on each piece drawing and for the overall length of the bed Set up the bed according to the specs on piece drawings including all form side reveals and bottom steel/plates Responsible for washing exposed aggregate (panels/full beds) Responsible for correct dunnage placement of finished product in yard Grind ends of panels Grind clean pallet of bed Scrape clean side forms and chamfer and oil Correctly set clamp/hook-ups to panel Dedication to safety, customer satisfaction, first time quality and efficiency Responsible for calling attention to any problems with finish Compliance to the “Fabcon Way” – “Every single day a little better than the day before”

Requirements

Ability to read tape measure, cast book and blue prints
Good communication and teamwork skills
Ability to operate machinery safely
Ability to work extensive overtime when required
Trouble shooting skills
Knowledge of concrete mixes
Mathematical aptitude

Nice To Haves

High school diploma or GED

Responsibilities

Operate jackhammer, forklift, bobcat
Follow appropriate work instructions to clean and upkeep all equipment
Cut and install wood block outs
Set up equipment used for casting bands and finishes
Proper placement of concrete on the bed to match the piece drawings
Monitor bed heat at computer
Lay out the bed with the proper dimensions on each piece drawing and for the overall length of the bed
Set up the bed according to the specs on piece drawings including all form side reveals and bottom steel/plates
Responsible for washing exposed aggregate (panels/full beds)
Responsible for correct dunnage placement of finished product in yard
Grind ends of panels
Grind clean pallet of bed
Scrape clean side forms and chamfer and oil
Correctly set clamp/hook-ups to panel
Dedication to safety, customer satisfaction, first time quality and efficiency
Responsible for calling attention to any problems with finish
Compliance to the “Fabcon Way” – “Every single day a little better than the day before”