Manufacturing Automatic Press Operator

Flex-N-Gate • Royal Oak, MI

1d • Onsite

About The Position

This position includes but not limited to: The set-up and operation of Automatic Presses equipped with coil feed lines.

Requirements

• Must pass written mechanical aptitude/knowledge test.
• Requires the ability to read instructions and perform tasks as instructed.
• Ability to read, comprehend and navigate through multiple HMI screens.
• Knowledge of Die Protection units such as Rexcon, smart-pac, wintriss, etc……
• Knowledge of Coil feedlines, Straighteners adjusting set and feeders adjusting pitch, pilot release, etc.………..
• Must be able to communicate in technical terms and relay information to other persons involved in equipment operation and maintenance.
• Use hand tools, lubricants, etc, and such hand devices as needed for a safe operation.
• Demonstrate a good Attendance record
• Must be able to lift at least 50lbs., bend, twist, squat, climb, kneel, stand or walk continuously in close, confined surroundings.
• Minimum high school diploma or equivalent required including high school math and reading proficiency, all additional education from college to training seminars in this related field is a plus.
• Must be able to work mandatory OT as required 6-7 days per week.

Responsibilities

• Controls the operation of the press and is responsible for the safety of those assigned to work with them when applicable.
• Operate Lift Trucks and overhead cranes for placement and/or removal of dies and equipment required for JCO
• Assists Die Setters and/or Line tenders with JCO’s Start to Finish
• Loads coils onto uncoiler, threads coil through feed line assuring proper alignment to die, adjusting set and pitch properly.
• Set-up all necessary items required to make job production ready-Guarding , bins , part exit conveyors, chutes, scrap shakers, die lubricant (Drawing Compound), Sensors, etc……..
• Performs adjustments, calibrations, alignments and modifications of automation systems and components when required assuring part Quality and performance is meet.
• Once JCO is complete running equipment assuring process is stable and parts off meets minimal visual inspection prior to calling for first piece.
• At least once per hour required to verify the parts they are producing meets quality standards and reports any concerns to the Supervisor.
• Advises supervisor when equipment does not meet proper capability to perform task efficiently so the appropriate skilled trades can be contacted.

What This Job Offers

• Job Type: Full-time
• Career Level: Entry Level
• Education Level: High school or GED