ATS Performance Testing Engineering Intern
About The Position
The Performance Testing Engineering Internship position is located within the Grid Technology Engineering & Evaluation (GTEE) organization within ATS. GTEE operates state-of-the-art laboratories for advanced T&D hardware & software validation, real-time hardware-in-the-loop power system modeling & simulation, and communication interface testing with highly qualified staff who leverage unique technical engineering design & fabrication skills to solve PG&E’s most complex engineering challenges in waveform analytics, system protection, electric reliability, DERs, V2X & electrification, microgrids, ADMS, DERMS, predictive analytics, and Integrated Grid Planning (IGP). The Performance Testing Engineering Internship position will be at the groundbreaking edge of this through supporting ongoing project testing of a variety of heat pump water heating products as well as HVAC and hot water distribution balancing valves and insulation qualities with the overarching goal of creating a decarbonized and reliable grid, while continuing to be the leader in reducing overall peak demand and total energy usage. Performance Testing Engineers generate critical test data and present results from energy efficiency test cases in support of ASHRAE (American Society for Heating, Refrigerating and Air Conditioning Engineers), ACEEE (American Council for an Energy Efficient Economy), AHRI (Air Conditioning Heating and Refrigeration Institute), DOE (Department of Energy), and CEC (California Energy Commission). Quite often, work performed among this team will lend itself to changes in California and National Building Codes and Standards. Work may range from general technical consultation or comprehensive support (add more here). The successful candidate is expected to support senior engineering staff on key initiatives including but not limited to: Support for testing residential and commercial HVAC systems up to 15 tons Support for testing commercial & residential water heaters and hot-water distribution systems Perform data analysis from liquid flowmeter testing ensuring accuracy
Requirements
- Qualified candidates are pursuing a Bachelor’s or Master’s degree in Mechanical Engineering at an accredited University
- Students must be continuing their education towards their degree during and/or after the internship
Nice To Haves
- EIT or FE certification
- 3.0 GPA or greater in both cumulative GPA and major GPA
- Interest in the Power System Equipment Testing, Power Flow Modeling and Analysis, Test Automation, Controls and Data Acquisition, Engineering Analytics, Power Electronics, Electric Vehicles, and DERs
- Engineering experience in utilities, municipalities, construction, or engineering consultation
- Experience with utility modeling software such as CYME, PSCAD, RSCAD, PSS/E, PSLF
- Programming experience including National Instruments Labview, Python, Matlab
- Ability to work in a team environment and support fellow team members
- Strong problem solving and analytical skills
- Strong communication skills, both oral and written
- Takes initiative and can work independently with minimal direction
Responsibilities
- Supporting senior staff with:
- Energy Efficiency Testing across all active test chambers
- Unit testing & data analysis
- Control & DAS programming
- Codes & standards literature review
- Assist with control system and system operation commissioning
- Travel may be required; frequency depends on the assignment and is typically less than 10%.
Stand Out From the Crowd
Upload your resume and get instant feedback on how well it matches this job.
What This Job Offers
Career Level
Intern
